WAX BAG INSTRUCTIONS
To install the wax bag, turn the power off at the ON/OFF switch, and unplug the unit from the electrical outlet.
Remove the access panel. Remove the two screws (A) securing the wax bag access panel (B), located on the user left side of the unit. Remove the panel and set it aside.
Install the wax bag. Verify that the wax bag protective liner (C) is open and ready to receive the wax bag (D). Remove the new wax bag from its packaging and carefully insert it into the access hole. The wax bag hose faces the rear of the unit. Remove the two wingnuts (E) located just inside the access hole. Align the mounting holes located in the wax bag flange with the two wingnut studs (F). Secure the wax bag with the two wingnuts.
CAUTION: Be careful to not rip or damage the wax bag on the wingnuts or wingnut studs when inserting the new wax bag.
MISE EN GARDE : lors de l'insertion du nouveau sac de cire, veillez à ne pas le déchirer ou l'endommager sur les écrous papillon ou sur leurs goujons.
Attach the hose clamp. Slide the hose clamp (G) over the end of the wax bag outlet hose (H). Position the clamp approximately three inches from the end of the hose and engage it, clamping it
(1) onto the wax bag hose to prevent spillage.
Connect the wax bag hose to the pump inlet hose. Cut the end of the wax bag hose one
CAUTION: Failure to release the hose clamp greatly shortens belt life.
MISE EN GARDE : la bride de serrage doit être relâchée sous peine de réduire de façon importante la durée de vie du tapis.
Replace the access panel. Replace the wax bag access panel, and secure it with the two screws.
11