NordicTrack NCTL11992 manual Assembly requires two people

ASSEMBLY

Assembly requires two people.	Set the treadmill in a cleared area and remove all packing materials. Do not
dispose of the packing materials until assembly is completed.		Assembly requires the included allen wrench
and your own phillips screwdriver	and wire cutters	.

Note: The underside of the treadmill walking belt is coated with high-performance lubricant. During shipping, a small amount of lubricant may be transferred to the top of the walking belt or the shipping carton. This is a normal condition and does not affect treadmill performance. If there is lubricant on top of the walking belt, simply wipe off the lubricant with a soft cloth and a mild, non-abrasive cleaner.

1. With the help of a second person, carefully raise Uprights			1
(69) to the position shown.
While a second person tips the treadmill to one side and
holds it, insert one of the Extension Legs (102) into the					69
treadmill as shown. Make sure that the Extension Leg is
turned so the Base Pad (99) is on the bottom.
Next, tip the treadmill to the other side		and insert the other
Extension Leg (not shown) in the same way. L		ower the			69
side of the treadmill so that both Extension Legs (102)
are resting flat on the floor.
					102
					99
2. Press the Lock Knob Sleeve (70) into the left Upright (69).			2
Make sure that the Lock Pin Collar (72) and the Spring
(71) are on the Lock Pin. Insert the Lock Pin into the Lock
Knob Sleeve (70) and the left Upright (69). Next, press
the Lock Knob Spacer (28) onto left Upright. Tighten the					69
Lock Knob (68) onto the Lock Pin.
			68
					70
				117	71
					72
					74
3. With the help of a second person, tip the Uprights (69)			3
down as shown.	Make sure that the Extension Legs
(102) remain in the Uprights.
Attach each Extension Leg (102) with two Screws (27) as				99
shown.
With the help of a second person, carefully tip the				Frame
Uprights (69) back to the vertical position.					69
			69
					27
				27	102
			99
				102
6