Assembly, Tighten the Extension Leg Bolts

ASSEMBLY

Assembly requires two persons. Set the treadmill in a cleared area and remove all packing materials. Do not dispose of the packing materials until assembly is completed.

Note: The underside of the treadmill walking belt is coated with high-performance lubricant. During shipping, a small amount of lubricant may be transferred to the top of the walking belt or the shipping carton. This is a normal condition and does not affect treadmill performance. If there is lubricant on top of the walking belt, simply wipe off the lubricant with a soft cloth and a mild, non-abrasive cleaner.

Assembly requires the included allen wrench and your own phillips screwdriver , and

rubber mallet . For help identifying the assembly hardware, see the drawings below. The num- ber in parentheses below each drawing is the key number of the part, from the PART LIST on pages 26 and 27. The number following the parentheses is the quantity needed for assembly. Note: Some small parts may have been pre-assembled. If a part is not in the parts bag, check to see if it has been pre-assembled. To avoid damaging plastic parts, do not use power tools for assembly.

Plastic Washer	Star Washer (67)–8	Extension Leg	1” Tek Screw (82)–4
(101)–4		Nut (91)–4

Extension Leg Bolt (87)–4		Console Bolt (72)–4

	1. Make sure that the power cord is unplugged.	1
		1
	With the help of a second person, carefully tip	Bracket
	With the help of a second person, carefully tip
	the treadmill onto its side as shown. Partially fold	67
	the Frame (55) so that the treadmill is more sta-	87
	ble. Do not fully fold the Frame until the	87
	ble. Do not fully fold the Frame until the
	treadmill is completely assembled.
	Insert an Extension Leg (97) into the indicated	91
	bracket on the base of the Uprights (85). Make
	sure that the Extension Leg is turned so the Base	97
	Pad (81) is on the side shown. If necessary, use	97
	Pad (81) is on the side shown. If necessary, use
	a rubber mallet to align the holes in the	81
	Extension Leg with the holes in the bracket.	81
	Extension Leg with the holes in the bracket.	85
		85
	Attach the Extension Leg (97) with two Extension
	Leg Bolts (87), two Star Washers (67), and two
	Extension Leg Nuts (91) as shown. Firmly
	tighten the Extension Leg Bolts.
	With the help of a second person, carefully tip the	55
	treadmill onto its other side.	55
	treadmill onto its other side.
		6

ASSEMBLY

1. Make sure that the power cord is unplugged.

ble. Do not fully fold the Frame until the

treadmill is completely assembled.

tighten the Extension Leg Bolts.