NordicTrack NTL29105.0 user manual Troubleshooting, Symptom the Power does not Turn on

Page 24

TROUBLESHOOTING

Most treadmill problems can be solved by following the steps outlined in this section. Find any symptoms that apply, and follow the steps listed. If further assistance is needed, please see the front cover of this manual.

1.SYMPTOM: THE POWER DOES NOT TURN ON

a.Make sure that the power cord is fully plugged into the treadmill. In addition, make sure that the power cord is plugged into a properly grounded outlet (see page 9).

b.Make sure that the key is inserted into the console.

c. Check the circuit breaker located on the treadmill near the power cord. If the switch protrudes as shown, the circuit breaker has tripped. To reset the circuit breaker, wait for five minutes and then press the switch back in.

d. Check the on/off switch located on the treadmill near the power cord. The switch must be in the “on” position.

2. SYMPTOM: THE POWER TURNS OFF DURING USE

c

 

Tripped

Reset

d

 

On

 

Position

 

a. Check the circuit breaker located on the treadmill frame near the power cord (see c. above). If the circuit breaker has tripped, wait for five minutes and then press the switch back in.

b. Make sure that the power cord is plugged in. If the power cord is plugged in, unplug it, wait for five minutes, and then plug it back in.

c. Remove the key from the console. Reinsert the key into the console.

d. Make sure that the on/off switch is in the “on” position.

e. If the treadmill still will not run, please see the front cover of this manual.

3. SYMPTOM: THE WALKING BELT SLOWS WHEN WALKED ON

a..If the walking belt is overtightened, performance may de- crease and the walking belt may be damaged. If the walking belt is properly tightened, you should be able to lift each edge of the walking belt 1 to 2 inches off the walking plat- form. If adjustments need to be made, first remove the key and unplug the power cord. Using the included allen wrench, turn both roller bolts counterclockwise 1/4 of a turn. Be careful to keep the walking belt centered. Then, plug in the power cord, insert the key, and use the treadmill for a few minutes. Repeat until the walking belt is properly tight- ened.

a

1”–2”

Roller

Bolts

b. If the walking belt still slows when walked on, please see the front cover of this manual.

24

Page 23 Page 25
Image 24
Page 23 Page 25
Contents QUESTIONS? Model No. NTL29105.0 Serial NoCall TOLL-FREE Table of Contents Important Precautions Underside Console Before YOU Begin Assembly Make sure that the Wire Harness is fully connectedHOW to Move the Treadmill Firmly tighten the eight Handrail BoltsHOW to USE the Chest Pulse Sensor HOW to PUT on the Chest Pulse SensorChest Pulse Sensor Care and Maintenance Chest Pulse Sensor TroubleshootingHOW to Connect the Power Cord Treadmill OperationFeatures of the Console Plug in the power cord Move the on/off switch to the on positionEnter your weight Getting StartedHOW to USE the Manual Mode Change the incline of the treadmill as desiredPace/Time-When Pulse/% Max-When you are using the hand Measure your heart rate if desiredHOW to USE Preset Programs Select one of the six preset programsPress the Start button to start the program HOW to USE PULSE-DRIVEN Programs Follow your progress with the main displayWhenkey. the program is completed, remove Select one of the three pulse-driven programsPress the Start button to start the program HOW to USE the Fitness Test Program Select the fitness test programEnter your age Your must enter your age to use the fitnessAudio Cable Headphones HOW to Connect Your Portable Stereo HOW to Connect Your Home StereoHOW to Connect Your Computer HOW to Connect Your VCRAudio Adapter Cable Insert the key fully into the console PressVCR. the Play button on your CD player orChange before the personal trainer describes the change HOW to USE Programs Directly from OUR WEB Site Follow the on-line instructions to start ProgramReturn to the treadmill and stand on the foot Information MODE/DEMO Mode Troubleshooting Symptom the Power does not Turn onSymptom the Power Turns OFF During USE Symptom the Walking Belt Slows When Walked onSymptom the Walking Belt is OFF-CENTER Symptom the Chest Pulse Sensor does not Function ProperlySymptom the Surface of the Walking Platform is Damaged Remove the key and unplug Power cord. RemoveExercise Guidelines Exercise IntensityWorkout Guidelines Exercise FrequencyR0106B Description QtyOrdering Replacement Parts DescriptionExploded DRAWING-Model No. NTL29105.0 120 113 104 112 111 109 106 119 108 121 105 83 82 116 118 Limited Warranty
Top Page Image Contents