NordicTrack NTL29105.0 user manual Symptom the Walking Belt is OFF-CENTER

Page 25

4.SYMPTOM: THE WALKING BELT IS OFF-CENTER

a.If the walking belt has shifted to the left: Remove the key and unplug the power cord. Using the included allen wrench, turn each roller adjustment bolt 1/4 of a turn in the direction shown. Be careful not to overtighten the walking belt. Then, plug in the power cord, insert the key, and use the treadmill for a few minutes. Repeat until the walking belt is centered.

b.If the walking belt has shifted to the right: Remove the key and unplug the power cord. Using the included allen wrench, turn each roller adjustment bolt 1/4 of a turn in the direction shown. Be careful not to overtighten the walking belt. Then, plug in the power cord, insert the key, and use the treadmill for a few minutes. Repeat until the walking belt is centered.

c.If the walking belt slips when walked on: Remove the key and unplug the power cord. Using the included allen wrench, turn both roller adjustment bolts clockwise 1/4 of a turn. When the walking belt is properly tightened, you should be able to lift each edge of the walking belt 1 to 2 inches off the walking platform. The center of the walking belt should just touch the walking platform. Make sure to keep the walking belt centered. Then, plug in the power cord, insert the key, and run the treadmill for a few min- utes. Repeat until the walking belt is properly tightened.

a

b

c

5.SYMPTOM: THE CHEST PULSE SENSOR DOES NOT FUNCTION PROPERLY

a.If the chest pulse sensor does not function properly, see CHEST PULSE SENSOR TROUBLESHOOTING on page 8.

b. If the chest pulse sensor still does not function properly, the battery should be changed. To replace the battery, locate the battery cover on the back of the sensor unit. Insert a coin into the slot in the cover and turn the cover counter- clockwise to the “open” position. Remove the cover.

Next, remove the old battery from the sensor unit. Insert a new CR 2032 battery, making sure that the writing is on top. In addition, make sure that the rubber gasket is in place in the sensor unit. Replace the battery cover and turn it to the closed position.

b

Cover

 

 

CR2032

 

Battery

 

Rubber

 

Gasket

6.SYMPTOM: THE INCLINE OF THE TREADMILL DOES NOT CHANGE CORRECTLY OR DOES NOT CHANGE WHEN IFIT.COM CDS AND VIDEOS ARE PLAYED

a.With the key in the console, press one of the INCLINE buttons. While the incline is changing, remove the key. After a few seconds, reinsert the key. The treadmill will automatically rise to the maximum incline level and then return to the minimum level. This will recalibrate the incline system.

25

Image 25
Contents Model No. NTL29105.0 Serial No QUESTIONS?Call TOLL-FREE Table of Contents Important Precautions Underside Console Before YOU Begin Make sure that the Wire Harness is fully connected AssemblyFirmly tighten the eight Handrail Bolts HOW to Move the TreadmillHOW to PUT on the Chest Pulse Sensor HOW to USE the Chest Pulse SensorChest Pulse Sensor Care and Maintenance Chest Pulse Sensor TroubleshootingTreadmill Operation HOW to Connect the Power CordFeatures of the Console Move the on/off switch to the on position Plug in the power cordEnter your weight Getting StartedChange the incline of the treadmill as desired HOW to USE the Manual ModePace/Time-When Measure your heart rate if desired Pulse/% Max-When you are using the handSelect one of the six preset programs HOW to USE Preset ProgramsPress the Start button to start the program Follow your progress with the main display HOW to USE PULSE-DRIVEN ProgramsWhenkey. the program is completed, remove Select one of the three pulse-driven programsPress the Start button to start the program Select the fitness test program HOW to USE the Fitness Test ProgramEnter your age Your must enter your age to use the fitnessAudio Cable Headphones HOW to Connect Your Home Stereo HOW to Connect Your Portable StereoHOW to Connect Your VCR HOW to Connect Your ComputerAudio Adapter Cable PressVCR. the Play button on your CD player or Insert the key fully into the consoleChange before the personal trainer describes the change Follow the on-line instructions to start Program HOW to USE Programs Directly from OUR WEB SiteReturn to the treadmill and stand on the foot Information MODE/DEMO Mode Symptom the Power does not Turn on TroubleshootingSymptom the Power Turns OFF During USE Symptom the Walking Belt Slows When Walked onSymptom the Chest Pulse Sensor does not Function Properly Symptom the Walking Belt is OFF-CENTERRemove the key and unplug Power cord. Remove Symptom the Surface of the Walking Platform is DamagedExercise Intensity Exercise GuidelinesWorkout Guidelines Exercise FrequencyDescription Qty R0106BDescription Ordering Replacement PartsExploded DRAWING-Model No. NTL29105.0 120 113 104 112 111 109 106 119 108 121 105 83 82 116 118 Limited Warranty