NordicTrack NTL07007.3 manual Troubleshooting, Problem The power turns off during use

Page 25

TROUBLESHOOTING

Most treadmill problems can be solved by following the steps below. Find the symptom that applies, and follow the steps listed. If further assistance is needed, please see the front cover of this manual.

PROBLEM: The power does not turn on

SOLUTION: a. Make sure that the power cord is plugged into a surge suppressor, and that the surge suppressor is plugged into a properly grounded outlet (see page 12). Use only a single-outlet surge suppres- sor that meets all of the specifications described on page 12. Important: The treadmill is not com- patible with GFCI-equipped outlets.

b. After the power cord has been plugged in, make sure that the key is inserted into the console.

c.Check the reset/off circuit breaker located on the treadmill frame near the power cord. If the switch protrudes as shown, the circuit breaker has tripped. To reset the circuit breaker, wait for five minutes and then press the switch back in.

c

Tripped Position

Reset

Position

PROBLEM: The power turns off during use

SOLUTION: a. Check the reset/off circuit breaker (see the drawing above). If the circuit breaker has tripped, wait for five minutes and then press the switch back in.

b.Make sure that the power cord is plugged in. If the power cord is plugged in, unplug it, wait for five minutes, and then plug it back in.

c.Remove the key from the console. Reinsert the key into the console.

d.If the treadmill still will not run, please see the front cover of this manual.

PROBLEM: The console displays remain lit when you remove the key from the console

SOLUTION: a. The console features a display demo mode, designed to be used if the treadmill is displayed in a store. If the displays remain lit when you remove the key, the demo mode is turned on. To turn off the demo mode, hold down the Stop button for a few seconds. If the displays are still lit, see THE INFORMATION MODE on page 22 to turn off the demo mode.

PROBLEM: The displays of the console do not function properly

SOLUTION: a. Remove the key from the console and UNPLUG THE POWER CORD. With the help of a second person, carefully tip the Uprights (74, 78) down.

There may be two #8 x 2" Screws (105) in the bot- tom of the Belly Pan (73). If there are, remove them. Note: A Phillips screwdriver with a shaft at least 5 in. (13 cm) long is required.

a

74

 

78

73

 

105

 

105

25

Page 24 Page 26
Image 25
Page 24 Page 26
Contents Model No. NTL07007.3 Serial No QUESTIONS?Call TOLL-FREE Table of Contents Important Precautions Page Before YOU Begin Assembly See the inset drawing. Tie the wire tie Make sure that the power cord is unpluggedDo not fully fold the Frame yet Nut the Wheel must turn freely. DiscardFully tighten the Bolts yet Be careful not to pinch the Upright WireSee assembly steps 4 and 6. Firmly tighten the 3/8 x 4 Bolts Pull on the sleeve to make sure that it is locked into place Be careful not to pinch the wires. Reattach HOW to Plug in the Power Cord Operation and AdjustmentPRE-LUBRICATED Walking Belt Console Diagram Features of the Console HOW to USE the Manual Mode HOW to Turn on the PowerSelect the manual mode Start the walking belt and adjust the speedChange the incline of the treadmill as desired Monitor your progress with the displays Matrix-When youTime/Incline dis Measure your heart rate if desired Select a preset workout HOW to USE a Preset WorkoutPress the Start button to start the workout Select the Custom Workout Center HOW to USE the Custom Workout CenterPress the Start Workout button to start the workout Put on the chest pulse sensor HOW to USE the Fitness Test WorkoutSelect the fitness test workout Press the Start Fitness Test button to start the workoutConnector is fully plugged HOW to USE the Sound SystemInsert an iFIT card and select a workout HOW to USE AN Ifit CardHOW to Adjust the Cushioning System Information ModeOptional Chest Pulse Sensor HOW to Fold the Treadmill for Storage HOW to Fold and Move the TreadmillHOW to Move the Treadmill HOW to Lower the Treadmill for USE Problem The power turns off during use TroubleshootingProblem The walking belt slows when walked on Page Exercise Intensity Exercise GuidelinesWorkout Guidelines Exercise FrequencySuggested Stretches Key No. Qty Description R0108AQty Exploded Drawing A-Model No. NTL07007.3 Exploded Drawing B-Model No. NTL07007.3 Exploded Drawing C-Model No. NTL07007.3 Exploded Drawing D-Model No. NTL07007.3 Limited Warranty Ordering Replacement PartsIcon Health & FITNESS, INC., 1500 S W., LOGAN, UT
Top Page Image Contents