NordicTrack NTL15007.0 user manual Troubleshooting, Problem The power turns off during use

Page 25

TROUBLESHOOTING

Most treadmill problems can be solved by following the steps below. Find the symptom that applies, and follow the steps listed. If further assistance is needed, please see the front cover of this manual.

PROBLEM: The power does not turn on

SOLUTION: a. Make sure that the power cord is plugged into a surge suppressor, and that the surge suppressor is plugged into a properly grounded outlet (see page 11). Use only a single-outlet surge suppres- sor that meets all of the specifications described on page 11. Important: The treadmill is not com- patible with GFCI-equipped outlets.

b. After the power cord has been plugged in, make sure that the key is inserted into the console.

c. Check the reset/off circuit breaker located on the treadmill frame near the power cord. If the switch pro- trudes as shown, the circuit breaker has tripped. To reset the circuit breaker, wait for five minutes and then press the switch to the reset position.

PROBLEM: The power turns off during use

c

Tripped

Reset

SOLUTION: a. Check the reset/off circuit breaker (see the drawing above). If the circuit breaker has tripped, wait for five minutes and then press the switch to the reset position.

b. Make sure that the power cord is plugged in. If the power cord is plugged in, unplug it, wait for five minutes, and then plug it back in.

c. Remove the key from the console. Reinsert the key into the console.

d. If the treadmill still will not run, please see the front cover of this manual.

PROBLEM: The displays of the console do not function properly

SOLUTION: a. Remove the key from the console and UNPLUG THE POWER CORD. Place the treadmill in the storage po- sition (see HOW TO FOLD THE TREADMILL FOR STORAGE on page 23).

Next, remove the two indicated 3/4" Screws (4).

Lower the treadmill (see HOW TO LOWER THE TREADMILL FOR USE on page 24). Remove the four indicated 3/4" Screws (4), and remove the Hood (44).

a

4

 

4

4

4

 

44

 

25

Page 24 Page 26
Image 25
Page 24 Page 26
Contents
Model No. NTL15007.0 Serial No QUESTIONS?Call TOLL-FREE Mon.-Fri a.m.-6 p.m. MST Sat a.m.-4 p.m. MSTTable of Contents Important Precautions Page Before YOU Begin Assembly Ful not to pinch the Upright Wire Harness See the inset drawing. Tie the wire tieNot shown. Do not tighten the Bolts yet Page Page HOW to PUT on the Chest Pulse Sensor HOW to USE the Chest Pulse SensorChest Pulse Sensor Care and Maintenance Chest Pulse Sensor TroubleshootingHOW to Plug in the Power Cord Operation and AdjustmentPRE-LUBRICATED Walking Belt Console Diagram Features of the Console HOW to Personalize Console Settings HOW to Turn on the PowerFollow the steps below to personalize the console settings Personalize console settings if desired HOW to USE the Manual ModeSelect the manual mode Start the walking belt and adjust the speedChange the incline of the treadmill as desired Adjust the incline of the treadmill to the lowest When you are finished exercising, removeWhen you fold the treadmill to the storage posi Measure your heart rate if desiredSelect a preset workout HOW to USE a Preset WorkoutPress the Start button to start the workout See on Select a custom workout HOW to Create a Custom WorkoutHOW to USE a Custom Workout Insert an iFIT card and select a workout HOW to USE AN Ifit CardHOW to Adjust the Cushioning System HOW to USE the Stereo Sound SystemHOW to Fold the Treadmill for Storage HOW to Fold and Move the TreadmillHOW to Move the Treadmill HOW to Lower the Treadmill for USE Problem The power turns off during use TroubleshootingTop Problem The walking belt slows when walked onPage Exercise Intensity Exercise GuidelinesWorkout Guidelines Exercise FrequencySuggested Stretches Qty Description R1107AQty Model ExplodedModel No Limited Warranty Ordering Replacement PartsIcon Health & FITNESS, INC., 1500 S W., LOGAN, UT
Top Page Image Contents