12. Remove the packaging material from the bottom | 12 |
of the Frame (56). See the inset drawing. Make sure that the 1/2" Rear Foot Nuts (111) are threaded all the way onto the Rear Feet (60). Turn the two Rear Feet all the way into the Frame.
See step 10. Discard the piece of cardboard.
Lower the Frame (56) (see HOW TO LOWER
THE TREADMILL FOR USE on page 28).
If one of the Rear Feet (60) doesn't sit flat on the floor, turn the Rear Foot until it does and then tighten the 1/2" Rear Foot Nut (111) against the Frame (56).
13. Press the Grommet (81) into the square hole in | 13 | |
the Base (97). | ||
|
97
81
14.Make sure that all parts are properly tightened before on the treadmill decals, remove the plastic, To protect the Note: Extra hardware may be included, Keep the included used to adjust the walking belt (see pages 30 and 31).
you use the treadmill. floor or carpet, place hex keys in a secure
If there are sheets of plastic a mat under the treadmill, place; one of the hex keys is
12