Ironman Fitness INSPIRE Maintenance Instructions, To Apply Lubricant to the Walking Board

Page 25

Maintenance Instructions

WARNING! Before performing any maintenance to your treadmill, always unplug the power cord from the surge protector.

CLEANING: Routine cleaning of your unit will extend the life of your unit.

WARNING! To prevent electrical shock, be sure the power to the treadmill is OFF and the unit is unplugged from the wall electrical outlet before attempting any cleaning or maintenance.

AFTER EACH WORKOUT: Wipe off the console and other treadmill surfaces with a clean, water damp- ened soft cloth to remove excess perspiration. USE NO CHEMICALS.

WEEKLY: Use of a treadmill mat is recommended for ease of cleaning. Dirt from your shoes contacts the belt and eventually makes it to underneath the treadmill. Vacuum underneath treadmill once a week.

DECK LUBRICATION: The walking belt has been pre-lubricated at the factory. However, it is recommend- ed that the walking board be checked periodically for lubrication to ensure optimal treadmill performance. Every 30 days or 30 hours of operation, lift the sides of the walking belt and feel the top surface of the walk- ing board as far under as you can reach. If you feel signs of silicone, no further lubrication is required. If it feels dry to the touch, lubrication is needed. Ironman Fitness recommends “Lube N Walk” for cleaning and lubricating the treadmill belt and deck. Ask your retailer or call Ironman Fitness at (800) 750-4766.

.

TO APPLY LUBRICANT TO THE WALKING BOARD

1)Position the walking belt so that the seam is located on top and in the center of the center of the walking board.

2)Insert the spray nozzle into the spray head of the lubricant can.

3)While lifting the side of the walking belt, position the spray nozzle between the walking belt and the board approximately 6” from the front of the treadmill. Apply the silicone spray to the walking board, moving from the front of the treadmill to the rear. Repeat this on the other side of the belt. Spray approximately 4 seconds on each side.

4)Allow the silicone to ‘set’ for one minute before using the treadmill.

WARNING: Do not over-lubricate the walking board. Excess lubricant should be wiped off with a clean towel.

25

Image 25
Contents Ironman Inspire Treadmill Table of Contents Safety Precautions and Tips Important Safety InformationBefore You Start Main Components AssemblyConsole Harness Connection IMPORTANT, Please Note Left and Right Upright InstallationLeft and Right Bottom Handle Cover Installation Congratulations Moving Instructions Power Requirements Console Panel Functions Resume AT the Speed the Treadmill WAS Moving Before Pausing Quick Start / Manual ModeFAN Body FAT Enter Incline Pause Power Start / Stop Program OperationProgram Mode Speed Incline 11INCLINE Program ProfilesHeart Rate Mode Program Instructions Heart Rate ModeMonitoring Your Heart Rate Monitoring Your Heart RateTarget Heart Rate Zone Workout Information Weight ManagementFrequency, Intensity, Time, Target Heart Rate Zone Frequency How Often Should You ExerciseWorkout Brisk and Rhythmic Exercise Exercise Practice Procedures Warm-Up WorkoutCool down Slow and Relaxed Exercise Inner Thigh Stretch not pictured Warm Up ExercisesChange to MPH or KPH Calibration Sequence Belt Adjustment To Apply Lubricant to the Walking Board Maintenance InstructionsSafety Interlock Error Messages Error MessagesOther Error Messages Treadmill loses power during use Troubleshooting GuideTreadmill Error Messages Treadmill will not startInspire Parts List Rev B Parts ListBelt Guide Bracket Exploded View Console Ironman Fitness Inspire Limited Warranty Warranty InformationService