Assembly
4.Install the Left and Right Uprights to the tread- mill base frame by inserting the upright connect- ing bracket into base frame as seen in Figure 3, using Allen Bolt
Next, install the Allen Bolt
Note: Do not tighten hardware in step 4 until step 7 is completed.
IMPORTANT, PLEASE NOTE:
While sliding the upright connecting bracket into the base frame, make sure the harness is installed inside the upright and pay attention not to pinch the wire harness. Excess Console Harness wiring should be placed inside the Left Upright.
5.Connect the Console Harness together as shown in Figure 4a.
Note: The upright console harness wire should be inserted through grommet in left upright before connecting to harness from console assembly.
6.Connect the Console to the Left and Right Uprights by sliding the Console connecting brack- ets into the end of the Left and Right Uprights as shown in Figure 4. Tighten into place using 5/16”- 18x45 Shoulder Allen Bolt (Qty. 2), Spring Washer 8 mm (Qty. 2), and Washer 9*16*1.6 mm (Qty. 2).
LEFT UPRIGHT | RIGHT UPRIGHT | |
| ||
| WASHER 9*16*1.6 mm | |
| SPRING WASHER 8 mm | |
| ALLEN BOLT | |
| 5/16”- 18x70 | |
| WASHER 9*16*1.6 mm | |
ALLEN BOLT | SPRING WASHER 8 mm | |
|
Figure 3: Left and Right Upright Installation
| CONSOLE |
| EKG HARNESS |
| SHOULDER ALLEN |
| BOLT |
| SPRING WASHER 8 mm |
CONSOLE | SMALL WASHER 9*16*1.6 mm |
HARNESS |
|
| RIGHT UPRIGHT |
LEFT UPRIGHT |
|
IMPORTANT, PLEASE NOTE:
While connecting the Console to the Left and Right Uprights pay attention not to pinch the wire harness.
Figure 4: Console Installation
LEFT UPRIGHT |
CONSOLE HARNESS |
GROMMET |
Figure 4a: Console Installation
7