TROUBLESHOOTING
Most treadmill problems can be solved by following the steps below. Find the symptom that applies, and follow the steps listed. If further assistance is needed, see the front cover of this manual.
PROBLEM: The power does not turn on
SOLUTION: a. Make sure that the power cord is plugged into a surge suppressor, and that the surge suppressor is plugged into a properly grounded outlet (see page 11). Use only a
b. After the power cord has been plugged in, make sure that the key is fully inserted into the console.
c. Check the reset/off circuit breaker located on the treadmill frame near the power cord. If the switch pro- trudes as shown, the circuit breaker has tripped. To reset the circuit breaker, wait for five minutes and then press the switch to the reset position.
c
Tripped
Reset
PROBLEM: The power turns off during use
SOLUTION: a. Check the reset/off circuit breaker (see the drawing above). If the circuit breaker has tripped, wait for five minutes and then press the switch to the reset position.
b. Make sure that the power cord is plugged in. If the power cord is plugged in, unplug it, wait for five minutes, and then plug it back in.
c. Remove the key from the console. Reinsert the key fully into the console.
d. If the treadmill still will not run, see the front cover of this manual.
PROBLEM: The displays of the console do not function properly
SOLUTION: a. Remove the key from the console and UNPLUG THE | a |
|
|
POWER CORD. Remove the two indicated Screws |
|
| |
|
|
| |
(4) from the front of the treadmill. Insert the tip of a |
| 4 |
|
slotted screwdriver between the Hood (58) and the |
| 58 | |
|
| ||
Frame (28) and against the tab on the bottom of the |
|
|
|
Hood in the location shown. Carefully lift the Hood |
|
|
|
while pressing on the tab with the screwdriver. Repeat |
|
|
|
on the other side. Remove the Hood. | 28 |
|
|
|
|
| |
Locate the Reed Switch (38) and the Magnet (40) on |
|
|
|
the left side of the Pulley (131). Turn the Pulley until | Top |
|
|
the Magnet is aligned with the Reed Switch. Make | View |
| 131 |
sure that the gap between the Magnet and the | 38 |
| 40 |
Reed Switch is about 3mm (1/8 in.). If necessary, |
| ||
|
|
| |
use a slotted screwdriver to move the Reed Switch |
|
|
|
slightly. Then, reattach the Hood (58). Run the tread- | 3mm |
|
|
mill for a few minutes to check for a correct speed |
|
| |
|
|
| |
reading. |
|
|
|
30