NordicTrack 30505.0 user manual

Page 4

21.Do not change the incline of the treadmill by placing objects under the treadmill.

22.When using iFIT.com programs, an electronic “chirping” sound will alert you when the speed and/or incline of the treadmill is about to change. Always listen for the “chirp” and be prepared. In some instances, the speed and/or incline may change before the per- sonal trainer describes the change.

23.When using iFIT.com programs, you can man- ually override the speed and incline settings by pressing the speed and incline buttons. However, when the next “chirp” is heard, the speed and/or incline will change to the next settings of the CD or video program.

24.Always remove iFIT.com CDs and videos from your CD player or VCR and disconnect your MP3 player when you are not using them.

25.Inspect and properly tighten all parts of the treadmill regularly.

26.Never insert or drop any object into any opening.

27.DANGER: Always unplug the power cord immediately after use, before cleaning the treadmill, and before performing the main- tenance and adjustment procedures de- scribed in this manual. Never remove the motor hood unless instructed to do so by an authorized service representative. Servicing other than the procedures in this manual should be performed by an authorized service representative only.

28.The treadmill is intended for in-home use only. Do not use the treadmill in any commer- cial, rental, or institutional setting.

29.If an outside antenna or cable system is con- nected, be sure that the antenna or cable sys- tem is grounded to provide some protection against voltage surges and built-up static charges. Section 810 of the National Electrical Code, ANSI/NFPA No. 70-1984, pro- vides information with respect to proper grounding of the mast and supporting struc- ture, grounding of the lead-in wire to an an-

tenna discharge unit, size of grounding con- ductors, location of antenna discharge unit, connection to grounding electrodes, and re- quirements for the grounding electrode.

30.An outside antenna system should not be lo- cated in the vicinity of overhead power lines or other electric light or power circuits, or where it can fall into such power lines or cir- cuits. When installing an outside antenna system, extreme care should be taken to keep from touching such power lines or circuits, as contact with them might be fatal.

31.To reduce the risk of electric shock, do not re- move the cover or the back of the television. There are no user serviceable parts inside. Refer servicing to qualified service personnel.

32.Upon completion of any service or repairs to the treadmill or the television, ask the service technician to perform safety checks to con- firm that the unit is in proper operating con- dition.

Use No. 10 AWG (5.3mm2) copper, No. 8 AWG (8.4mm2) aluminum, No. 17 AWG (1.0mm2) copper-clad steel or bronze wire, or larger as a ground wire.

Secure an antenna lead-in and ground wires to the house with stand-off insulators spaced from 4 to 6 feet (1.22 to 1.83m) apart.

Mount an antenna discharge unit as close as possible to where the lead-in enters the house.

Use a jumper wire not smaller than No. 6 AWG (13.3mm2) copper, or the equivalent when a separate antenna-grounding elec- trode is used. See NEC Section 810-21 (j).

Note to CATV system installer: This reminder is provided to call the CATV system installer’s at- tention to Article 820-40 of the NEC that provides guidelines for proper grounding and, in particu- lar, specifies that the cable ground shall be con- nected to the grounding system of the building, as close to the point of cable entry as practical.

4

Image 4
Contents QUESTIONS? Model No Serial NoTable of Contents Important Precautions Page Power Lines Before YOU Begin Assembly One connector and try again Washers 114. Firmly tighten the four Console BoltsThis step Upright 111 make sure that the top of the LongPage Page HOW to Plug in the Power Cord Operation and AdjustmentPRE-LUBRICATED Walking Belt Features of the Console HOW to Turn on the Power HOW to USE the Manual ModeAdjust the cushioning system as desired Change the incline of the treadmill as desiredMeasure your heart rate if desired Turn on the fans if desiredHOW to USE a Preset Program Select one of the preset programsAdjust the intensity level of the program if Desired Identify yourself as user A, B, C, or DHOW to Create a Custom Program Select one of the custom programsHOW to USE a Custom Program Enter a maximum target heart rate setting HOW to USE a Pulse ProgramSelect a pulse program Adjust the cushioning system as desired HOW to Connect Your Portable Stereo HOW to Connect Your MP3 Player or CD PlayerAudio Cable HOW to Connect Your Home Stereo HOW to Connect Your ComputerHOW to Connect Your VCR Press the Play button on your MP3 player, CD Player, or VCRMeasure your heart rate if desired Follow the on-line instructions to start Program Directly from OUR WEB SiteReturn to the treadmill and stand on the foot HOW to Operate the Personal Television Diagram of the Television ControlsHOW to Connect AN Antenna HOW to Connect a Catv CableHOW to Connect a VCR Press the Power button to turn on TelevisionPress the Volume buttons to adjust the volume Basic Television OperationHOW to USE the Information Mode HOW to USE the Remote ControlPress the Stop button again and add or delete Channels HOW to Move the Treadmill Press the Stop button again and restoreConsole to the factory settings if desired Information modeProblem The power turns off during use TroubleshootingTop Problem The walking belt slows when walked on Problem Television reception is poorProblem The remote control does not function properly Conditioning Guidelines Exercise IntensityWorkout Guidelines Exercise FrequencyR0605A Qty DescriptionOrdering Replacement Parts Limited Warranty Exploded DRAWING-Model No 134 125 100 141 142 117 139 108 114 107 110 109 101