Reebok RCTL07809.0 manual Be careful not to pinch the wires in the Right Handrail

Page 12

12.Be careful not to pinch the wires in the Right Handrail (105).

Attach the console assembly to the Right Handrail (105) with two #8 x 3/4" Screws (1), a 1/4" x 1 1/4" Bolt (6), and a 1/4" Star Washer (10). Repeat this step on the left side of the console assembly. Start all four Screws and both Bolts before tightening any of them. See steps 4, 6, and 9–10. Tighten all the bolts used in these assembly steps.

13.If necessary, press the Left Accessory Tray (94) and the Right Accessory Tray (99) into the con- sole assembly.

12

 

Console Assembly

 

105

 

1

6 10

 

13

94

 

Console

99

Assembly

 

12

Image 12
Contents QUESTIONS? Contact OUR Customer SER Vice Department DirectlyTable of Contents Important Precautions Power cord, and switch the reset/off cir Treadmill, and before performing the mainteCuit breaker to the off position when Treadmill is not in use. See the drawing onBefore YOU Begin Assembly Make sure that the power cord is unplugged Do not fully fold the Frame yetOvertighten the Locknut the Wheel must Turn freely With a second Bolt Spacer 84, 3/8 x 4 Bolt 3/8 Star Washer Right Upright do not fully tighten the Bolts YetBolts yet 3/4 Bolt 112. Do not fully tighten Resistance Knob Attach the other resistance mechanism toRight Upright 79 as described above Attach the other Crosswalk Arm 98 as deAgain. if the Connectors are not CON PowerCareful not to pinch the wires Be careful not to pinch the wires in the Right Handrail Raise the Frame 53 to the position shown Operation and Adjustment HOW to Plug in the Power CordPRE-LUBRICATED Walking Belt Console Diagram Features of the ConsoleHOW to Turn on the Power HOW to USE the Manual ModeSelect the manual mode Insert the key into the consoleMeasure your heart rate if desired. Before using Turn on the fan if desiredHOW to USE a Preset Workout Select one of the preset workouts. To select oneHOW to USE AN Ifit Workout Insert an iFit card and select a workoutInformation Mode HOW to USE the Stereo Sound SystemHOW to USE the Crosswalk Arms HOW to Fold and Move the Treadmill HOW to Fold the Treadmill for StorageHOW to Move the Treadmill HOW to Lower the Treadmill for USETroubleshooting Problem The power turns off during useCompatible with GFCI-equipped outlets Reed Switch is about 1/8 in mm. If nec Problem The walking belt slows when walked onTop Make sure that the gap between the MagnetProblem Solution Exercise Guidelines Exercise IntensityWorkout Guidelines Exercise FrequencyPart LIST-Model No. RCTL07809.0 R1009A110 Resistance Knob Userʼs Manual Exploded Drawing A-Model No. RCTL07809.0 R1009A Exploded Drawing B-Model No. RCTL07809.0 R1009A Exploded Drawing C-Model No. RCTL07809.0 R1009A Exploded Drawing D-Model No. RCTL07809.0 R1009A Ordering Replacement Parts Limited Warranty