serVICe aCCess PorT
The two interchangeable type RJ45 networking ports (A) are located on the back of the display console. These network ports, located behind the display console rear access door, allow for console software updates.
PoWer CorD roUTInG
A
The power cord can be run straight from the treadmill, shortened and exited out the
For efficient cord management, the following routing options are recommended:
With the power cord unplugged, insert the clips in the appropriate holes. See the illustration below. Use Hole Pattern 1 or 2 to locate the clips and secure the power cord with the clips, taking up any slack between clips.
note: It may be necessary to tip the treadmill to route the power cord properly.
To plug the power cord into an outlet in front of the treadmill, use Hole Pattern 1 for outlets located at the front of the machine.
note: To accommodate treadmill incline, at least two feet (24”) of power cord is required between the outlet and the last power cord clip for outlets in front of the treadmill.
To plug the power cord into an outlet in rear of the treadmill, use Hole Pattern 2 for outlets located at the rear of the machine.
WarnInG: Make sure that there is a 6.5 foot clearance behind the treadmill. Contact life fitness Customer services for an optional longer power cord if necessary.
WarnInG: Insure that the power cord (a) does not contact the striding belt or get pinched between the frame (C), lift arm (b) or the wheel. failure to follow this warning may result in serious injury.
aVerTIsseMenT : s'assurer que le cordon d'alimentation n'entre pas en contact avec le tapis et ne soit pas pincé entre le cadre, le bras de levage ou la roue. le
note: When using Pattern 1, it is extremely important to route the power cord BETWEEN the lift frame and the main frame.
11