13.Lower the Uprights (77, 78) as shown.
See the inset drawing. Position the Uprights (77, 78) so that the Frame (55) is centered be- tween the Uprights.
Firmly tighten the 3/8" x 2 1/2" Bolt (1) and then tighten the 3/8" x 2 1/4" Bolts (8) on each side of the treadmill. Do not overtighten the 3/8" x 2 1/2" Bolts.
14.Attach the ground wire on the Upright Wire (74) to the indicated hole in the Base (85) with a #8 x 1/2" Screw (12).
Press the indicated Grommet (21) into the Right Upright (78).
Raise the Right Upright (78) and the Left Upright (not shown).
15.Attach the Latch Housing (76) to the Left Upright (77) with two #8 x 3/4" Screws (7).
Make sure that the large hole in the Latch Housing is on the side shown. Do not over- tighten the Screws.
Locate the Latch Pin Assembly (75). Remove the knob from the pin. Make sure that the collar and the spring are on the pin as shown. Insert the pin into the Latch Housing (76), and tighten the knob back onto the pin.
13 | Side View | 1 |
|
| 8 |
| 77, 78 |
|
| 55 |
|
77 | View from Above | 78 |
55 |
14 | 21 | 74 | 78 |
|
|
| |||
|
|
| ||
|
|
|
| |
85 |
|
|
|
|
Hole |
|
|
|
|
Ground |
| 12 |
|
|
Wire |
|
|
| |
15 |
|
| 76 |
|
|
|
|
| |
| Knob |
|
| Large |
75 | 7 |
| Pin | Hole |
| 77 | |||
Spring |
| |||
| Collar |
|
| |
16. Make sure that all parts are properly tightened before you use the treadmill. Note: Extra hardware may be included. Keep the included hex keys in a secure place; one of the hex keys is used to adjust the walking belt (see page 21). To protect the floor or carpet, place a mat under the treadmill.
12