Attaching the Curl PAD

To use the Curl Pad (29), first remove the 50mm Round Slanted Inner Cap (66) from the Seat Frame

(6). Then, insert the Curl Post (9) into the Seat Frame and secure the Curl Post with the Curl Knob (64).

Remove the Curl Pad (29) and replace the 50mm Round Slanted Inner Cap (66) when performing an exercise that does not require the Curl Pad.

ATTACHING THE CURL BAR

To use the Curl Bar (28), first attach the housing cables to the leg lever (see ATTACHING THE LEG LEVER on the previous page). Attach the clip on the Curl Bar to the hook on the Leg Lever (8).

PLUGGING IN THE RESISTANCE SYSTEM

Plug the indicated end of the Transformer (122) into the Back Mech Cover (12). Plug the other end of the Transformer into a 120-volt outlet. All indicators and displays on the console will flash once; the console will then be ready for use. The motor may be heard while the resistance system calibrates itself.

Important: Always plug in the transformer when using the resistance system.

The resistance system will need to be calibrated man- ually the first time it is used. To do this, plug in the Transformer (122) as described above. Then, press and hold the LBS up and down buttons on the Console (30) for three seconds. The motor will be heard while the resistance system calibrates itself.

Follow this procedure whenever the resistance system does not seem to be working properly and needs to be recalibrated.

29
9
66
64
6
28
8
12
122
Press
30