ASSEMBLY
Assembly requires two people. Place all parts of the elliptical crosstrainer in a cleared area and remove the packing materials. Do not dispose of the packing materials until assembly is completed. In addition to the
included allen wrenches, assembly requires a phillips screwdriver | , an adjustable | ||
wrench | , and a rubber mallet | . |
|
As you assemble the elliptical crosstrainer, use the drawings below to identify the small parts used in assembly. The number in parenthesis below each drawing refers to the key number of the part, from the PART LIST on page 22. The second number refers to the quantity used in assembly. Note: Some small parts may have been
M8 Split | M8 Washer (33)Ð4 | M10 Flat | M10 Nylon |
Washer (58)Ð4 |
| Washer (44)Ð5 | Locknut (26)Ð4 |
Incline Axle | M10 x 24mm Screw (90)Ð1 | Console Screw (35)Ð4 | |
Screw (30)Ð4 |
|
|
|
|
| Rear Stabilizer Bolt (60)Ð2 | |
Pedal Screw (43)Ð6 |
|
| |
| Front Stabilizer Bolt (86)Ð2 |
|
|
|
| 56mm Spacer (22)Ð2 | |
| 3/4Ó Axle Cap (61)Ð2 | Plastic Pedal |
|
| Spacer (85)Ð2 |
| |
|
|
| |
| 5 |
|
|