5.Identify the Left Pedal Arm (3), which has an ÒLÓ sticker attached to it. Next, identify the Left Pedal (41), which has the letter ÒLÓ molded onto the bottom.
Turn over the Left Pedal Arm (3) as shown. Insert the three plastic posts on the Left Pedal (41) into the three indicated holes in the Left Pedal Arm. Make sure that the Left Pedal is turned as shown. Attach the Left Pedal with three Pedal Screws (43).
Attach the Right Pedal (not shown) to the Right Pedal Arm (not shown) in the same way.
6.Apply a small amount of grease to the axle on the left Crank Arm (6).
Side a Plastic Pedal Spacer (85) and the Left Pedal Arm (3) onto the axle on the left Crank Arm (6). Note: It may be helpful to use a rubber mallet to tap these parts on. Be careful not to confuse the Left Pedal Arm with the Right Pedal Arm (not shown); look at the position of the round tube to correctly identify the Left Pedal Arm. Next, tap a 3/4Ó Axle Cap (61) onto the axle.
Attach the Right Pedal Arm (not shown) in the same way.
7.Carefully pivot the Upright (2) to the position shown. Secure the Upright by tightening the M10 x 24mm Screw (90) with the M10 Flat Washer (44) into the Upright and the Frame (1).
5 |
|
|
| 43 |
|
3 |
|
|
|
| Open Side |
41 |
| Plastic Posts |
|
| |
6 |
|
|
|
| Grease |
| 3 | 6 |
|
| |
|
| 85 |
| 61 | Round |
|
| Tube |
7 |
|
|
| 2 |
|
90 | 44 |
|
|
| |
|
| 1 |
7