8.This step requires the help of a second person.
Remove the four Console Screws (35) and the four M10 Flat Washers (44) from the Console (87).
Hold the Console (87) in the position shown and connect the console wire harness to the Upper Wire Harness (51). Remove the rubber band from the Upper Wire Harness and push the Upper Wire Harness and the console wire harness down into the Upright (2). Set the Console on the Upright. Make sure that the con- sole wire harness is not pinched between the Console and the Upright.
Hold the Handlebar (18) in the position shown. Align the four holes in the Handlebar with the four holes in the plate at the top of the Upright (2). Attach the Handlebar and the Console (87) to the Upright with the four Console Screws (35) and the four Console Washers (44) that you removed previously. Note: Thread all four Console Screws into the Console before tightening them.
8 |
|
| 87 |
Console |
|
Wire |
|
Harness |
|
51 |
|
| 18 |
| 2 |
44 |
|
35 | 35 |
|
9.Make sure that all parts of the elliptical crosstrainer are properly tightened. Note: Some hardware may be left over after assembly is completed. To protect the floor or carpet from damage, place a mat under the elliptical crosstrainer.
8