1.
To make assembly easier, read the information on page 5 before you begin assembling the elliptical exerciser.
Remove the four screws and the four shipping brackets attached to the Frame (1). Discard the screws and the shipping brackets.
Then, tighten four Leveling Feet (52) into the underside of the Frame (1).
2.Identify the Frame Cover (54) and orient it as shown. Press the Frame Cover posts into the indicated holes in the Frame (1).
Identify the Upright (2) and orient it as shown. While a second person holds the Upright near the Frame (1), connect the Upper Wire Harness (81) to the Lower Wire Harness (82).
Tip: Avoiding pinching the Wire Harnesses (81, 82) during this step. Insert the Upright (2) into the Frame (1). Attach the Upright with four M10 x 19mm Patch Screws (61) and four M10 Split Washers (79). Do not tighten the Patch
1 |
52 |
1 |
Shipping Bracket |
Screw |
2 |
Avoid pinching the wires during this step
2
81
Screws yet.
79
61
54
82
1
79
61
Holes 
6