5.Identify the Left Pedal (10). Attach the Left Pedal to the Left Pedal Leg (4) with two M8 x 58mm Button Screws (83).
Attach the Right Pedal (11) to the Right Pedal Leg (5) in the same way.
Attach two Pedal Wheels (28) and a Wheel Spacer
(31) to the Wheel Frame (30) with an M10 x 78mm Bolt Set (65). Make sure that the Bolt Set, Pedal Wheels,
and Wheel Spacer are oriented as shown; the bushing in the Wheel Spacer (see the inset drawing) must be facing away from the Wheel Frame.
Attach the other two Pedal Wheels and the other
Wheel Spacer (not shown) to the Wheel Frame (not shown) on the Right Pedal Leg (5) in the same way.
6.Have another person hold the Upright (2) in the posi- tion shown. Make sure that the Upright is turned as shown in drawing 7 below.
Connect the Upper Wire Harness (115) to the Lower Wire Harness (42). Carefully pull the upper end of the Upper Wire Harness to remove the slack from the Wire Harnesses. Insert the Upright (2) into the Frame (1). Be careful to avoid disconnecting or pinching the Wire Harnesses. Attach the Upright with two M10 x 110mm Button Screws (70), two M10 Split Washers (73), and two Spacers (109); make sure that the curved sides of the Spacers are facing the
Upright. Be careful to avoid damaging the Wire Harnesses with the Button Screws.
7.Have another person hold the Left Handlebar (24) near the Upright (2) as shown. Connect the left Pulse Sensor Wire (20) to the Pulse Extension Wire (114).
Slide the upper end of the Left Handlebar (24) into the tube on the front of the Upright (2), while sliding the lower end of the Left Handlebar onto the tube on the left side of the Upright. Attach the upper end of the Left Handlebar with two M8 x 41 mm Button Bolts (85) and
two M8 Jam Nuts (86); be careful not to damage the Pulse Sensor Wire (20) or the Pulse Extension Wire
(114) as you insert the Button Bolts. Make sure
that the Jam Nuts are resting in the hexagonal holes in the Left Handlebar. Attach the lower end of
the Left Handlebar with an M8 x 38mm Button Bolt (105) and an M8 Jam Nut (86).
Attach the Right Handlebar (23) to the Upright (2) in the same way.
11
28
65
Bushing
83
6
2_
73
70<109
23
105
86