ASSEMBLY
Assembly requires two persons. Place all parts of the elliptical exerciser in a cleared area and remove the packing materials. Do not dispose of the packing materials until assembly is completed. In addition to the in-
cluded hex keys, assembly requires an adjustable wrench .
As you assemble the elliptical exerciser, use the drawings below to identify small parts. The number in parentheses below each drawing is the key number of the part, from the PART LIST near the end of this manual. The number following the parentheses is the quantity needed for assembly. Note: Some small parts may have been pre- assembled. If a part is not in the hardware kit, check to see if it has been preassembled.
M8 Small | M10 Split | Wave Washer | M10 Washer | M8 Washer |
Washer | Washer | |||
M4 x 16mm | M4 x 19mm | M8 x 19mm Button | M8 Nylon | M10 Nylon |
Screw | Screw | Screw | Locknut | Locknut |
M8 x 38mm Button | M8 x 55mm Bolt | M10 x 13mm Button | ||
Bolt |
| Set | Screw | |
M10 x 25mm Patch | M10 x 65mm Bolt |
| ||
Screw |
| Set |
| |
| M10 x 116mm Carriage Bolt |
|
| |
| M10 x 123mm Button Screw | Thrust Washer | ||
|
|
|
| |
|
|
|
| |
|
| 5 |
|
|