MAINTENANCE AND TROUBLESHOOTING
Inspect and tighten all parts of the elliptical exerciser regularly. Replace any worn parts immediately.
To clean the elliptical exerciser, use a damp cloth and a small amount of mild soap. Important: To avoid damage to the console, keep liquids away from the console and keep the console out of direct sunlight.
BATTERY REPLACEMENT
If the console displays become dim, the batteries should be replaced; most console problems are the result of low batteries. See assembly step 11 on page 10 for replacement instructions.
HOW TO LEVEL THE ELLIPTICAL EXERCISER OR ELIMINATE FLEXING IN THE FRAME
If the elliptical exerciser rocks on your floor during use, turn one or both of the Leveling Feet (98) until the rocking motion is eliminated.
| 88 |
14, 15 |
|
12 | 1 |
| |
| 95 |
| 116 |
98 |
|
If the elliptical exerciser flexes in the center during use, turn the Center Foot (95) until the flexing is elimi- nated.
HOW TO ELIMINATE RUBBING OF THE DISCS
See the drawing above. If the Discs (12) rub against the Side Shields (14, 15) during use, make sure that the Center Foot (95) is attached to the Frame (1). If the Center Foot is attached, loosen the two indicated Bolt Sets (88) and the two M4 x 16mm Screws (116) in each side of the elliptical exerciser.
Adjust the position of the Side Shields (14, 15) until the Discs (12) no longer rub against them, and then tighten the Bolt Sets (88) and the M4 x 16mm Screws (116).
HANDGRIP PULSE SENSOR TROUBLESHOOTING
If the handgrip pulse sensor does not function proper- ly, see step 5 on page 15.
HOW TO ADJUST THE BELT
If the pedals slip |
|
while you are |
|
pedaling, even |
|
while the resis- |
|
tance is adjusted |
|
to the highest |
|
setting, the belt |
|
may need to be |
|
adjusted. To | 13 |
adjust the belt, | 12 |
first carefully pry |
|
off the left Disc |
|
Cover (13) using a flat screwdriver. Next, remove the four Screws (not shown) from the center of the left Disc (12). Gently rotate the Disc Cover and the Disc away from the elliptical exerciser.
Loosen, but do |
| |
not remove, the |
| |
three 1/4" x |
| |
19mm Button |
| |
Screws (114). |
| |
Insert the shaft of | 47 | |
a screwdriver | ||
48 | ||
downward | ||
114 96 | ||
between the | ||
Idler (47) and the |
| |
Idler Pulley (48). |
| |
Pull the top of the |
| |
screwdriver |
|
toward the rear of the elliptical exerciser until the Belt (96) is tight, and then tighten the three Button Screws.
Reattach the left disc with the four screws and then reattach the left disc cover.
19