9.Apply a film of grease to the barrel of an M8 x 55mm Bolt Set (92) and to a 7mm Spacer (55). Slide an M8 Washer (69) and the Spacer onto the barrel.
While another person holds the front end of the Left Pedal Leg (14) inside of the bracket on the left Handlebar Leg (17), insert the barrel of the Bolt Set (92) through both parts. Next, slide a 7mm Spacer (55) and an M8 Washer (69) onto the end of the barrel of the Bolt Set. Then, turn the screw of the Bolt Set a few turns into the barrel. Do not overtighten the Bolt Set; the left Handlebar Leg must be able to pivot freely.
Attach the right Handlebar Leg (not shown) to the Right Pedal Leg (not shown) in the same way.
See step 7. Tighten the four M8 x 38mm Button Bolts (58).
10.While another person holds the Console (74) near the Upright (2), connect the Pulse Jumper Wire (76) to the console pulse wire, and connect the Upper Wire Harness (77) to the console wire har- ness. Insert the excess wires into the Upright.
Hold the Console (74) against the Upright (2). Make sure that no wires are pinched. Attach the Console with four M4 x 16mm Screws (47).
11.Attach the Water Bottle Holder (26) to the Frame
(1) with two M4 x 22mm Screws (57).
9 |
|
|
|
| 17 |
| 55 |
|
|
| 92 |
Grease | 55 |
| 69 |
92 |
| 69 | 14 |
10 |
|
| 74 |
|
|
| |
2 |
|
|
|
47 |
| 77 |
|
76 |
|
|
|
11 |
|
|
|
|
|
| 1 |
|
|
| 26 |
|
|
| 57 |
12.Make sure that all parts of the elliptical exerciser are properly tightened. Cover the floor beneath the el- liptical exerciser to protect the floor from damage. Note: Some extra hardware may be left over.
10