Life Fitness SM40 manual LAT Pulldown Cable Routing, Screw the cable into the weight stack

Page 14

SM40 Unpacking & Assembly Instructions

Bolt the cable to the weight stacks as shown in Figure 17. Thread the 7/8” nut up on the cable bolt as shown at left. Screw the bolt down into the weight stack as shown at right. Tighten the bolt with a 7/8” combination wrench.

Figure 17. Screw the cable into the weight stack.

LAT PULLDOWN CABLE ROUTING

Route the lat pulldown cable as shown in Figure 18. Screw the cable into the weight stack as shown previously in Figure 17.

Figure 18. Lat pulldown cable routing.

14

Image 14

Contents Stack MULTI-JUNGLE SM40 Unpacking and Assembly Instructions Materials and Tools Required for Assembly Assembly TimeParts box contents UnpackingAssembly Place the weight cube in its final resting spotConfiguration for 2-3/4 and 3 bolts Mount lat top V, tricep top U, adjustable crossover top Install the weight stacks. To do this Bolt the floating pulleys into the 190 lb weight stacks Mount the benches to the frame Bolt the benches to the frame Installing the Cables Removing the pulley boltsAdjustable Crossover Cable Routing Adjustable crossover cable routingAdjustable crossover cable end detail LOW ROW Cable RoutingScrew the cable into the weight stack LAT Pulldown Cable RoutingTricep Pushdown Cable Routing Tricep pushdown cable routingHardware . Assembly Parts HardwareHardware . Rubber caps Hardware . Cable jam nut Hardware . CablesHardware . Top assemblies Hardware . Weight stack rubber bumpers Hardware . Floating pulleyParts List Pulley hardware InstalledHardware installed Floating pulley