Life Fitness SM40 manual Mount lat top V, tricep top U, adjustable crossover top

Page 6

SM40 Unpacking & Assembly Instructions

3.Mount the tops. Mount the 56” lat top to the cell by inserting two of the large 7/16” by 6” bolts using the hardware configuration shown in Figure 5. Use a 5/8” socket with extension and combination wrench. Mount the 29” tricep top and adjustable crossover top to the frame and connecting beam. You will need to remove the pulleys from the teardrop pulley assemblies to gain clearance for the socket wrench extension. Leave the pulleys out of the housings until the cables have been installed.

3/8” x 3” (2)

T

7/16” x 6” (4)

V

U

Remove pulleys from housings to give clearance to socket extension

Figure 5. Mount lat top (V), tricep top (U), adjustable crossover top (V).

Figure 6. Mount rubber bumpers and the weight stacks.

6

Image 6
Contents Stack MULTI-JUNGLE SM40 Unpacking and Assembly Instructions Materials and Tools Required for Assembly Assembly TimeParts box contents UnpackingAssembly Place the weight cube in its final resting spotConfiguration for 2-3/4 and 3 bolts Mount lat top V, tricep top U, adjustable crossover top Install the weight stacks. To do this Bolt the floating pulleys into the 190 lb weight stacks Mount the benches to the frame Bolt the benches to the frame Installing the Cables Removing the pulley boltsAdjustable Crossover Cable Routing Adjustable crossover cable routingAdjustable crossover cable end detail LOW ROW Cable RoutingScrew the cable into the weight stack LAT Pulldown Cable RoutingTricep Pushdown Cable Routing Tricep pushdown cable routingHardware . Assembly Parts HardwareHardware . Rubber caps Hardware . Cable jam nut Hardware . CablesHardware . Top assemblies Hardware . Weight stack rubber bumpers Hardware . Floating pulleyParts List Pulley hardware InstalledHardware installed Floating pulley