Life Fitness SM50 manual LAT Pulldown Cable Routing, Screw the cable into the weight stack

Page 15

SM50 Unpacking & Assembly Instructions

Bolt the cable to the weight stacks as shown in Figure 18. Thread the 7/8” nut up on the cable bolt as shown at left. Screw the bolt down into the weight stack as shown at right. Tighten the bolt with a 7/8” combination wrench.

Figure 18. Screw the cable into the weight stack.

LAT PULLDOWN CABLE ROUTING

Route the lat pulldown cable as shown in Figure 19. Screw the cable into the weight stack as shown previously in Figure 18.

Figure 19. Lat pulldown cable routing.

15

Image 15

Contents M051-K50-B115 Assembly Time Materials and Tools Required for AssemblyUnpacking Parts box contentsSM50 main components seats and cables removed for clarity AssemblySet the weight stack cells Configuration for 2-3/4 and 3 bolts Configuration for 6 bolts Putting on the weight stacks SM50 Unpacking & Assembly Instructions Use a pinch bar to align the seat frame holes to the cubes SM50 Unpacking & Assembly Instructions Removing the pulley bolts Installing the CablesCrossover cable routing Crossover Cable RoutingLow row cable routing LOW ROW Cable RoutingLAT Pulldown Cable Routing Screw the cable into the weight stackTricep pushdown cable routing Tricep Pushdown Cable RoutingHardware Hardware . Assembly PartsSM50 Unpacking & Assembly Instructions Hardware . Cables Hardware . Cable jam nutHardware . Top assemblies Hardware . Floating pulleys Hardware . Weight stack rubber bumpersParts List Floating pulley InstalledHardware installed Pulley hardware