Life Fitness SM50 manual Set the weight stack cells

Page 5

SM50 Unpacking & Assembly Instructions

Figure 3. Set the weight stack cells.

2.Bolt on the teardrop pulleys above the benches (see Figure 4) on the 4 stack cell using two 3/8” x 2-3/4” hex head bolts. Include the 3/8” flat washer, end cap washers, end caps and 3/8” Nyloc nut. Use the bolt configuration shown in Figure 5. You may wish to use a pinch bar to align the bolt holes.

3/8” x 2-3/4” (6)

Figure 4. Bolt on the teardrop pulleys.

Image 5

Contents M051-K50-B115 Assembly Time Materials and Tools Required for AssemblyUnpacking Parts box contentsSM50 main components seats and cables removed for clarity AssemblySet the weight stack cells Configuration for 2-3/4 and 3 bolts Configuration for 6 bolts Putting on the weight stacks SM50 Unpacking & Assembly Instructions Use a pinch bar to align the seat frame holes to the cubes SM50 Unpacking & Assembly Instructions Removing the pulley bolts Installing the CablesCrossover cable routing Crossover Cable RoutingLow row cable routing LOW ROW Cable RoutingLAT Pulldown Cable Routing Screw the cable into the weight stackTricep pushdown cable routing Tricep Pushdown Cable RoutingHardware Hardware . Assembly PartsSM50 Unpacking & Assembly Instructions Hardware . Cables Hardware . Cable jam nutHardware . Top assemblies Hardware . Floating pulleys Hardware . Weight stack rubber bumpersParts List Hardware installed InstalledPulley hardware Floating pulley