Assembly
Step 1: Put the Treadles on the Base
Parts:
•TreadClimber® Base Assembly
•TreadClimber® Treadle Assembly
Hardware:
• (4) 3/8” X 1 1/4” Hex Bolts (preassembled)
Note: Hardware is only hand tightened. Finish tightening the hardware in Step
Tools:
•9/16” Open End Wrench (included)
•Scissors or other cutting tool
•Ruler
Note: This step requires two people.
Note: Tighten the outside bolts on the rear roller casting first, then the inner bolts.
Figure
Align roller casting so it lays flush
on base
Figure
Figure
Assembly Manual | 7 |