Bowflex 5000, 1000, 3000 Inspect the Assembly, Attach the Frame Covers, #10 Phillips Head Screws

Page 18

Assembly

Step 10: Inspect the Assembly

10-1Remove the plastic film from the console face.

10-2Inspect all of the attachments and securely tighten all of the bolts before proceeding to Step 11.

Step 11: Attach the Frame Covers

Parts:

•TreadClimber® Base and Treadle assembly from Step 10

•(1) Left Plastic Frame Cover

•(1) Right Plastic Frame Cover

Hardware:

• (6) #10 Phillips Head Screws

Tools:

• #2 Phillips Head Screwdriver (included)

11-1Attach the left and right Plastic Frame Covers to the sides of the base frame with (6) #10 Phillips Head Screws (3 per side) and the provided #2 Phillips screwdriver (See Figures 11-1 and 11-2).

Figure 11-1

Figure 11-2

14Assembly Manual

Image 18

Contents Bowflex TreadClimber 1000, 3000 Page Table of Contents Page Product Specifications TC1000 TC3000Important Safety Instructions Obey the following warningsBasic Assembly Principles Before You AssembleSelect Your Workout Area Parts Box 1 containsQty1 Assembly Hardware Bag Contains the followingBox 2 contains the TreadClimber treadles Hardware HardwarePut the Treadles on the Base AssemblyTreadClimber Base Assembly TreadClimber Treadle Assembly 8 X 1 1/4 Hex Bolts preassembledConnect the Speed and Step Wires TC3000 and TC5000 only Speed WireTreadClimber Base and Treadle assembly from Step Drive Belt Lock the TreadlesAttach the Drive Belt Attach the Uprights 16 x 1 Button Head Screws Attach the Upright Junction Attach the Console Handlebar Assembly 16 x 1 Button Head Screws 16 Flat Washers SAEAttach the Hydraulic Cylinders TreadClimber Base and Treadle assembly from StepAttach the Cosmetic Plugs Hex Key included Open End Wrench includedInspect the Assembly Attach the Frame Covers#10 Phillips Head Screws Adjust Speed Sensor and Attach the Rear Cover TreadClimber Base and Treadle assembly from Step Rear Cover#2 Phillips Head Screwdriver included Attach the Drive CoversAttach the Side Foot Support Platforms 4 x 1 Flat Head ScrewsAttach the Power Cord Apply DecalsMain Power Switch On Calibration TC3000 and TC5000 onlyReplace the three back covers If Calibration Fails Screen Displays Cal Fail MessageIf calibration is successful If calibration is not successfulTroubleshooting Ments, stop and refer to drive belt checklist Sion should be adjusted. If both belts stop butBe adjusted Drive belt Unplug power from unit. Wait 5-minutes toDiagnostics on control board Mill modeBelt drive line. Using a ½ wrench, tighten Connection of speed sensor to jumper wireTC1000 Console Assembly Ordering Replacement PartsExploded Views Walking Belts Rear Belt Guide Right Drive Cover Page Important Contact Numbers United States OfficesNautilus Bowflex Schwinn Fitness StairMaster Universal