Bowflex 5000, 1000, 3000 manual Troubleshooting

Page 24

Troubleshooting

 

 

 

Condition / Problem

Things to Check

Solution

Unit will not power up/turn on/

Outlet

Make sure outlet is functioning correctly. Verify

start

 

this by plugging another object (ex: lamp) into

 

 

the outlet. If outlet is connected to a light

 

 

switch, check to make sure it is on. If outlet is

 

 

not functioning find a working outlet.

 

Power cord not plugged in

Make sure the power cord is firmly secured to

 

 

A/C inlet on the unit and firmly inserted into a

 

 

non-GFI wall socket.

 

Power switch turned off

Make sure the power switch at the rear of the

 

 

unit is in the “ON” position.

 

Safety key not plugged in

Plug Safety Key into console (See Emergency

 

 

Stop Procedure within the Important Safety

 

 

Precautions section).

 

LED Diagnostic needed

Remove rear plastic covers and contact cus-

 

 

tomer service for assistance.

Speed displayed is not accurate

Display set to wrong unit of mea-

Change display units (See Owner’s Manual).

 

sure. (English/Metric)

 

 

Out of calibration

Re-calibrate machine (See Calibration procedure

 

 

in Owner’s or Service Manual).

Heart rate not displayed while

Transmitter not making good con-

Moisten skin contact area on the chest strap.

using chest strap

tact with skin

 

 

Electromagnetic interference

Turn off any television, AM radio, microwave, or

 

 

computer within 6 feet (2 meters) of the Tread-

 

 

Climber® fitness machine.

 

Chest strap transmitter

Test chest strap with another HR monitoring

 

 

device such as HR watch or a machine at a gym.

 

 

If transmitter has good skin contact and still is

 

 

not found to be emitting HR signal, replace chest

 

 

strap transmitter.

 

HR receiver

If chest strap is known to work with other

 

 

devices and no sources of interference are

 

 

present, or console has been tested with a Pulse

 

 

Simulator and is not receiving the signal, replace

 

 

the HR receiver.

Walking belt misalignment

Rear belt guides

Belts should ride on top of triangular black belt

 

 

guides at rear of treadles.

 

Tracking adjustment

Belts are not required to be perfectly centered

 

 

and are typically farther out in the rear than they

 

 

are in the front. This may vary depending on

 

 

user’s stride. If belt is tracking to one side far

 

 

enough to cause rubbing of belt follow belt align-

 

 

ment procedure in Owner’s Manual.

Speed dependent grinding or

Belt alignment

Check walking belt alignment. Belt contact with

scraping noise in all modes

 

metal guides under treadle can make loud grind-

 

 

ing sound. If belts are misaligned follow belt

 

 

alignment procedure in Owner’s Manual.

 

Rollers or motor

Contact customer service for further assistance.

 

 

 

20Assembly Manual

Page 23 Page 25
Image 24
Page 23 Page 25
Contents Bowflex TreadClimber 1000, 3000 Page Table of Contents Page Product Specifications TC1000 TC3000Important Safety Instructions Obey the following warningsBasic Assembly Principles Before You AssembleSelect Your Workout Area Parts Box 1 containsQty1 Assembly Hardware Bag Contains the followingBox 2 contains the TreadClimber treadles Hardware HardwareAssembly TreadClimber Base Assembly TreadClimber Treadle AssemblyPut the Treadles on the Base 8 X 1 1/4 Hex Bolts preassembledConnect the Speed and Step Wires TC3000 and TC5000 only Speed WireTreadClimber Base and Treadle assembly from Step Drive Belt Lock the TreadlesAttach the Drive Belt Attach the Uprights 16 x 1 Button Head ScrewsAttach the Upright Junction Attach the Console Handlebar Assembly 16 x 1 Button Head Screws 16 Flat Washers SAETreadClimber Base and Treadle assembly from Step Attach the Cosmetic PlugsAttach the Hydraulic Cylinders Hex Key included Open End Wrench includedInspect the Assembly Attach the Frame Covers#10 Phillips Head Screws Adjust Speed Sensor and Attach the Rear Cover TreadClimber Base and Treadle assembly from Step Rear CoverAttach the Drive Covers Attach the Side Foot Support Platforms#2 Phillips Head Screwdriver included 4 x 1 Flat Head ScrewsAttach the Power Cord Apply DecalsMain Power Switch On Calibration TC3000 and TC5000 onlyIf Calibration Fails Screen Displays Cal Fail Message If calibration is successfulReplace the three back covers If calibration is not successfulTroubleshooting Sion should be adjusted. If both belts stop but Be adjustedMents, stop and refer to drive belt checklist Drive belt Unplug power from unit. Wait 5-minutes toMill mode Belt drive line. Using a ½ wrench, tightenDiagnostics on control board Connection of speed sensor to jumper wireTC1000 Console Assembly Ordering Replacement PartsExploded Views Walking Belts Rear Belt Guide Right Drive Cover Page Important Contact Numbers United States OfficesNautilus Bowflex Schwinn Fitness StairMaster Universal

5000, 1000, 3000 specifications

The Bowflex series, specifically the Bowflex 3000, 1000, and 5000, represents a transformative approach to home fitness, combining versatility with compact design to cater to various workout needs. Each model is meticulously engineered to deliver a range of resistance options, targeting different fitness levels and goals.

The Bowflex 3000, one of the more compact models, is designed for those looking to optimize their workouts in limited spaces. It features the patented Power Rod technology, which provides smooth, consistent resistance throughout the entire movement, mimicking the feel of free weights while reducing the risk of injury. The 3000 offers 210 pounds of resistance, expandable to 310 pounds with additional purchase, allowing users to progress as they build strength. With over 30 exercises available, it facilitates comprehensive muscle engagement, targeting everything from arms and legs to core muscles. Its SpaceSaver design means it can easily fit into a home gym without taking up much room.

Moving to the Bowflex 1000, this model enhances the workout experience with an impressive 210 pounds of resistance through advanced Power Rod technology. The 1000 also incorporates an adjustable bench that allows for various positions, enhancing the range of exercises that can be performed. It offers over 25 different exercises, showcasing its adaptability to suit different training styles—from strength training to muscle toning. The Bowflex 1000 is particularly user-friendly, designed for both beginners and experienced fitness enthusiasts.

Finally, the Bowflex 5000 is the powerhouse of the lineup, featuring an expansive 310 pounds of resistance, which is ideal for serious athletes looking for maximum strength training. It includes a more robust frame and a wider range of motion, allowing for advanced exercises. The Bowflex 5000 stands out with adjustable leg attachments, enabling users to engage in various lower-body workouts comprehensively. Like its counterparts, it employs the Power Rod technology, providing a safe and effective resistance training experience.

In summary, whether you're choosing the Bowflex 3000 for its compact design, the Bowflex 1000 for its versatility, or the Bowflex 5000 for its advanced capabilities, each model offers unique features that cater to various fitness goals. With a focus on innovative resistance technology and user-friendly design, these machines are essential additions to any home gym, enabling users to achieve their fitness aspirations effectively and conveniently.
Top Page Image Contents