Bowflex 3000, 5000, 1000 manual Attach the Drive Covers, Attach the Side Foot Support Platforms

Page 20

Assembly

Step 13: Attach the Drive Covers

Parts:

•TreadClimber® Base and Treadle assembly from Step 12

•(1) Left Plastic Drive Cover

•(1) Right Plastic Drive Cover

Hardware:

• (6) #10 Phillips Head Screws

Figure 13-1

Tools:

• #2 Phillips Head Screwdriver (included)

13-1Attach the left and right Plastic Drive Covers to the sides of the base with (6) #10 Phillips Head Screws (3 per side) and the provided #2 Phillips screwdriver (See Figures 13-1). Install upper screw first.

Note: Do not tighten hardware until all screws have been installed.

Step 14: Attach the Side Foot

Support Platforms

Parts:

•TreadClimber® Base and Treadle assembly from Step 13

•(1) Left Foot Support Platform

•(1) Right Foot Support Platform

Hardware:

•(6) 1/4” x 1” Flat Head Screws

Tools:

•5/16” Hex Key (included)

14-1Attach the right and left side foot support platforms to each treadle with (6) 1/4” x 1” Flat Head Screws (3 per side) (See Figures 14-1 and 14-2).

Figure 14-1

Figure 14-2

16Assembly Manual

Image 20

Contents Bowflex TreadClimber 1000, 3000 Page Table of Contents Page Product Specifications TC1000 TC3000Important Safety Instructions Obey the following warningsSelect Your Workout Area Basic Assembly PrinciplesBefore You Assemble Parts Box 1 containsBox 2 contains the TreadClimber treadles Qty1 Assembly Hardware BagContains the following Hardware HardwareAssembly TreadClimber Base Assembly TreadClimber Treadle AssemblyPut the Treadles on the Base 8 X 1 1/4 Hex Bolts preassembledConnect the Speed and Step Wires TC3000 and TC5000 only Speed WireAttach the Drive Belt TreadClimber Base and Treadle assembly from Step Drive BeltLock the Treadles Attach the Uprights 16 x 1 Button Head ScrewsAttach the Upright Junction Attach the Console Handlebar Assembly 16 x 1 Button Head Screws 16 Flat Washers SAE TreadClimber Base and Treadle assembly from Step Attach the Cosmetic Plugs Attach the Hydraulic Cylinders Hex Key included Open End Wrench included#10 Phillips Head Screws Inspect the AssemblyAttach the Frame Covers Adjust Speed Sensor and Attach the Rear Cover TreadClimber Base and Treadle assembly from Step Rear CoverAttach the Drive Covers Attach the Side Foot Support Platforms#2 Phillips Head Screwdriver included 4 x 1 Flat Head ScrewsAttach the Power Cord Apply DecalsMain Power Switch On Calibration TC3000 and TC5000 onlyIf Calibration Fails Screen Displays Cal Fail Message If calibration is successfulReplace the three back covers If calibration is not successfulTroubleshooting Sion should be adjusted. If both belts stop but Be adjustedMents, stop and refer to drive belt checklist Drive belt Unplug power from unit. Wait 5-minutes toMill mode Belt drive line. Using a ½ wrench, tightenDiagnostics on control board Connection of speed sensor to jumper wireExploded Views TC1000 Console AssemblyOrdering Replacement Parts Walking Belts Rear Belt Guide Right Drive Cover Page Important Contact Numbers United States OfficesNautilus Bowflex Schwinn Fitness StairMaster Universal