Bowflex 5000, 3000 manual Exploded Views, TC1000 Console Assembly, Ordering Replacement Parts

Page 27

Exploded Views

Ordering Replacement Parts

Call a Bowflex® TreadClimber® Representative at 1-800-NAUTILUS (1-800-628-8458) to order replacement parts and get assistance with your specific replacement or service requirements.

TC1000

Console Assembly

Overlay

(Not illustrated)

	Console Top
Electronics	Limit Switch
	Limit Switch
Tether Housing	Tether Housing
Assembly
	Console Bottom

	TC Handlebar
Upright Junction
Covers
	Round Plug
	Plugs
Upright	Upright
Upright

Cylinders/Shocks

Assembly Manual

23

Image 27

Contents Bowflex TreadClimber 1000, 3000 Page Table of Contents Page TC1000 TC3000 Product SpecificationsObey the following warnings Important Safety InstructionsBasic Assembly Principles Before You AssembleSelect Your Workout Area Box 1 contains PartsQty1 Assembly Hardware Bag Contains the followingBox 2 contains the TreadClimber treadles Hardware Hardware8 X 1 1/4 Hex Bolts preassembled AssemblyTreadClimber Base Assembly TreadClimber Treadle Assembly Put the Treadles on the BaseSpeed Wire Connect the Speed and Step Wires TC3000 and TC5000 onlyTreadClimber Base and Treadle assembly from Step Drive Belt Lock the TreadlesAttach the Drive Belt 16 x 1 Button Head Screws Attach the UprightsAttach the Upright Junction 16 x 1 Button Head Screws 16 Flat Washers SAE Attach the Console Handlebar AssemblyHex Key included Open End Wrench included TreadClimber Base and Treadle assembly from StepAttach the Cosmetic Plugs Attach the Hydraulic CylindersInspect the Assembly Attach the Frame Covers#10 Phillips Head Screws TreadClimber Base and Treadle assembly from Step Rear Cover Adjust Speed Sensor and Attach the Rear Cover4 x 1 Flat Head Screws Attach the Drive CoversAttach the Side Foot Support Platforms #2 Phillips Head Screwdriver includedApply Decals Attach the Power CordCalibration TC3000 and TC5000 only Main Power Switch OnIf calibration is not successful If Calibration Fails Screen Displays Cal Fail MessageIf calibration is successful Replace the three back covers Troubleshooting Drive belt Unplug power from unit. Wait 5-minutes to Sion should be adjusted. If both belts stop butBe adjusted Ments, stop and refer to drive belt checklistConnection of speed sensor to jumper wire Mill modeBelt drive line. Using a ½ wrench, tighten Diagnostics on control boardTC1000 Console Assembly Ordering Replacement PartsExploded Views Walking Belts Rear Belt Guide Right Drive Cover Page United States Offices Important Contact NumbersNautilus Bowflex Schwinn Fitness StairMaster Universal