Healthrider HREL3226.0 manual Wire harnesses

7. Attach the Left Pedal Arm (21) to the left Upper	7
Body Arm (6) with an M8 x 23mm Button Screw
		6
(65), an M8 Washer (64), and a Pedal Leg Cover
(23).
Apply grease to a Large Wave Washer (20) and		73
slide it onto the Left Crank Arm (42). Then, attach		21
the Left Pedal Arm (21) to the Left Crank Arm with
an M8 x 25mm Patch Screw (70) and an M8 Large	64
Washer (81).
Repeat this step for the other side of the elliptical	65	23	20
exerciser.		70	81
See step 3. Tighten the four M8 x 19mm Patch
Screws (73).
8. The Console (10) requires four “D” batteries (not	8
included); alkaline batteries are recommended.

IMPORTANT: If the elliptical exerciser has been
exposed to cold temperatures, allow it to warm
to room temperature before inserting batteries
into the Console. If you do not do this, the con-
sole displays or other electronic components
may become damaged. Remove the battery cover		Batteries
from the Console. Insert four batteries into the	10
Console; make sure that the batteries are orient-
ed as shown by the diagram inside the battery
compartment. Then, reattach the battery cover.
		Battery
		Cover
9. While another person holds the Console (10) near	9
the Upright (2), connect the Upper Wire Harness
(18) to the wire harness on the Console.
Attach the Console (10) to the Upright (2) with four		18
M4 x 16mm Screws (60). Be careful not to pinch		10
the wire harnesses.
Attach the Water Bottle Holder (17) to the Upright		60
(2) with two M4 x 22mm Screws (66).
	60	17
		2
		66

8