Huffy M6011141 manual Do not Over Tighten

Page 12

1.Assemble pole bracket (12) using bolt (13) and Lock Nut (14) as shown.

IMPORTANT!

DO NOT OVER

TIGHTEN

2.

Attach pole assembly to base using carriage bolts (15) washers(10) and nuts (11) as shown. Two people are required for this step.

14

WARNING!

TWO PEOPLE REQUIRED

FOR THIS PROCEDURE.

FAILURE TO FOLLOW THIS

WARNING COULD RESULT

IN SERIOUS INJURY AND/OR

PROPERTY DAMAGE.

15

10 11

13

12

IMPORTANT!

THE CUT CORNERS OF THE POLE BRACKET NEED TO FACE TOWARD THE BACK OF THE BASE AS SHOWN.

ID#

M6011141

04/06

12

Image 12

Contents Write Model Number From Box Here Before YOU Start Safety Instructions Warranty Card Front Back Parts List See Hardware Identifier ID#Hardware Identifier Plastic Spacers & Caps Item #61 Item #44 Item #45 Item #46 Item #48 Item #47 Pole Sections Should have aOverlap Pole Sections Should have a Minimum OverlapAND/OR Do not Over Tighten ID# ID# AND/OR Tighten just until washers 50 stop moving FIG. a ID# Toward Board Upper Elevator tube Lower Elevator tube Pole ID# ID# Orientation BracketInstall net Fill Base FIG. a Section G Height Adjustment and Moving Label Sistema portátil Manual del propietario Avertissement Warnung ¡ADVERTENCIAOutils ET Matériel Requis ID# Achtung Consignes DE Sécurité Wichtig ¡IMPORTANTECerceau Korbrand Borde Liste DES Pièces Teileliste FrançaisLista DE Piezas #14 #30 #21 #31 #11 #47 #50 #10 #43 Identificadores DEL Herraje Espaciadores DE Plástico Y Tapas Nota Centrale Inférieure Mitte Unten Media InferiorRemarque ID# Wichtig ¡IMPORTANTE M601114 04/06 ID# UND/ODER ET/OU Wichtig ¡IMPORTANTE FIG. a ABB. a DIE Korrekte Ausrichtung Beachten ID# ID# Remarque Hinweis / Nota Installez le cerceau Slam Jam sur le panneau ID# Remarque Hinweis Nota Avertissement Warnung ¡ADVERTENCIA FIG.A ABB. a Réglage DE LA Hauteur Höhenverstellung Ajuste DE LA Altura