Huffy M6011141 manual Orientation, Bracket

Page 22

12.	Install Rim to Backboard

A.Fit rim (51) securely into bracket (61) as shown. Allow T-bolt (48) to slip through center hole in rim (51).

B.Install reinforcement bracket (44) onto T-bolt (48) as shown.

C.Install spring (46) onto T-bolt (48) as shown.

D.Install special nut (47) and washer (45) onto T-bolt (48).

E. Tighten special nut (47) until flush with end of T-bolt (48).

A.B.

44

51

48

48

61

47

45

C.D.

46

48

NOTE:

ORIENTATION

OF BRACKET

44

			48	45
			48
			E.
			47
ID#	M6011141	04/06		22

Image 22

Contents Write Model Number From Box Here Before YOU Start Safety Instructions Warranty Card Front Back Parts List See Hardware Identifier ID#Hardware Identifier Plastic Spacers & Caps Item #61 Item #44 Item #45 Item #46 Item #48 Item #47 Should have a Pole SectionsOverlap Pole Sections Should have a Minimum OverlapAND/OR Do not Over Tighten ID# ID# AND/OR Tighten just until washers 50 stop moving FIG. a ID# Toward Board Upper Elevator tube Lower Elevator tube Pole ID# ID# Orientation BracketInstall net Fill Base FIG. a Section G Height Adjustment and Moving Label Sistema portátil Manual del propietario Avertissement Warnung ¡ADVERTENCIAOutils ET Matériel Requis ID# Achtung Consignes DE Sécurité Wichtig ¡IMPORTANTECerceau Korbrand Borde Liste DES Pièces Teileliste FrançaisLista DE Piezas #14 #30 #21 #31 #11 #47 #50 #10 #43 Identificadores DEL Herraje Espaciadores DE Plástico Y Tapas Nota Centrale Inférieure Mitte Unten Media InferiorRemarque ID# Wichtig ¡IMPORTANTE M601114 04/06 ID# UND/ODER ET/OU Wichtig ¡IMPORTANTE FIG. a ABB. a DIE Korrekte Ausrichtung Beachten ID# ID# Remarque Hinweis / Nota Installez le cerceau Slam Jam sur le panneau ID# Remarque Hinweis Nota Avertissement Warnung ¡ADVERTENCIA FIG.A ABB. a Réglage DE LA Hauteur Höhenverstellung Ajuste DE LA Altura