Huffy M6011141 manual Safety Instructions

Page 3

SAFETY INSTRUCTIONS

FAILURE TO FOLLOW THESE SAFETY INSTRUCTIONS MAY RESULT IN SERIOUS INJURY,

PROPERTY DAMAGE AND WILL VOID WARRANTY.

Owner must ensure that all players know and follow these rules for safe operation of the system.

To ensure safety, do not attempt to assemble this system without following the instructions carefully. Proper and complete assembly, use and supervision is essential for proper operation and to reduce the risk of accident or injury. A high probability of serious injury exists if this system is not installed, maintained, and operated properly.

If using a ladder during assembly, use extreme caution.

Check base regularly for leakage. Slow leaks could cause the system to tip over unexpectedly

Seat the pole sections properly (if applicable). Failure to do so could allow the pole sections to separate during play and/or during transport of the system.

Climate, corrosion or misuse could result in system failure.

If technical assistance is required, contact Huffy Sports.

Minimum operational height is 6’6” (1.98m) to the bottom of backboard.

Most injuries are caused by misuse and/or not following instructions.

Use caution when using this unit.

42

HEIGHT ADJUSTMENT

TO ADJUST BACKBOARD:

 

 

1

1.

While holding handle, remove pin.

3

2.

Move elevator up or down to

 

 

desired height.

2

3. Replace pin full length to lock system at desired height.

2

MOVING SYSTEM

1

3

4

1.Adjust basketball backboard height to lowest position.

2.While holding pole, rotate

basketball system forward until wheels engage with ground.

3. Move basketball system to desired location.

2

4. Carefully rotate basketball system upright.

5. Check system for stability.

511679 05/05

3

04/06

ID#

M6011141

Image 3
Contents Write Model Number From Box Here Before YOU Start Safety Instructions Warranty Card Front Back ID# Parts List See Hardware IdentifierHardware Identifier Plastic Spacers & Caps Item #61 Item #44 Item #45 Item #46 Item #48 Item #47 Pole Sections Should have aOverlap Minimum Overlap Pole Sections Should have aAND/OR Do not Over Tighten ID# ID# AND/OR Tighten just until washers 50 stop moving FIG. a ID# Toward Board Upper Elevator tube Lower Elevator tube Pole ID# ID# Bracket OrientationInstall net Fill Base FIG. a Section G Height Adjustment and Moving Label Avertissement Warnung ¡ADVERTENCIA Sistema portátil Manual del propietarioOutils ET Matériel Requis ID# Achtung Consignes DE Sécurité ¡IMPORTANTE WichtigCerceau Korbrand Borde Français Liste DES Pièces TeilelisteLista DE Piezas #14 #30 #21 #31 #11 #47 #50 #10 #43 Identificadores DEL Herraje Espaciadores DE Plástico Y Tapas Centrale Inférieure Mitte Unten Media Inferior NotaRemarque ID# Wichtig ¡IMPORTANTE M601114 04/06 ID# UND/ODER ET/OU Wichtig ¡IMPORTANTE FIG. a ABB. a DIE Korrekte Ausrichtung Beachten ID# ID# Remarque Hinweis / Nota Installez le cerceau Slam Jam sur le panneau ID# Remarque Hinweis Nota Avertissement Warnung ¡ADVERTENCIA FIG.A ABB. a Réglage DE LA Hauteur Höhenverstellung Ajuste DE LA Altura