Huffy M6011141 manual Id#

Page 20

9.Attach upper elevator tubes (33) to backboard support brackets (52) using spacers (53), bolt (57), and nut (21) as shown.

IMPORTANT!

Tighten ALL Hardware from Steps 6-8 After this Assembly is Completed.

53

56

33 57

53

52

56

33

57

21

56

33

56

21

33

ID#

M6011141

04/06

20

Image 20

Contents Write Model Number From Box Here Before YOU Start Safety Instructions Warranty Card Front Back Parts List See Hardware Identifier ID#Hardware Identifier Plastic Spacers & Caps Item #61 Item #44 Item #45 Item #46 Item #48 Item #47 Overlap Pole SectionsShould have a Pole Sections Should have a Minimum OverlapAND/OR Do not Over Tighten ID# ID# AND/OR Tighten just until washers 50 stop moving FIG. a ID# Toward Board Upper Elevator tube Lower Elevator tube Pole ID# ID# Orientation BracketInstall net Fill Base FIG. a Section G Height Adjustment and Moving Label Sistema portátil Manual del propietario Avertissement Warnung ¡ADVERTENCIAOutils ET Matériel Requis ID# Achtung Consignes DE Sécurité Wichtig ¡IMPORTANTECerceau Korbrand Borde Liste DES Pièces Teileliste FrançaisLista DE Piezas #14 #30 #21 #31 #11 #47 #50 #10 #43 Identificadores DEL Herraje Espaciadores DE Plástico Y Tapas Nota Centrale Inférieure Mitte Unten Media InferiorRemarque ID# Wichtig ¡IMPORTANTE M601114 04/06 ID# UND/ODER ET/OU Wichtig ¡IMPORTANTE FIG. a ABB. a DIE Korrekte Ausrichtung Beachten ID# ID# Remarque Hinweis / Nota Installez le cerceau Slam Jam sur le panneau ID# Remarque Hinweis Nota Avertissement Warnung ¡ADVERTENCIA FIG.A ABB. a Réglage DE LA Hauteur Höhenverstellung Ajuste DE LA Altura