Star Trac E-ST manual Maintenance Mode, Engl

OK Key: Updates (saves) the values of all parameters in non-volatile memory, and exits Manager Mode.

NOTE: To exit Manager Mode without saving any values or settings, press the QUICK START key.

The items that you may display and change with the previous keys are:

	Lowest	Highest	Default
Item	Value	Value	Value	Meaning
Serial No	0	65535	0	Serial number (set by factory)
Date	01/00	12/99	01/05	Manufacture date for the Stepper (set by factory)
Display Vers 1	01.00	99.99	N/A	Display panel software version (set by factory)
Display Vers 2	01.00	99.99	N/A	Display panel software version (set by factory)
LCB Vers	01.00	99.99	N/A	Display panel software version (set by factory)
Units	English	Metric	English	English = units of pounds, feet,
				Metric = units of kilograms, meters
Time	5	99	99	Maximum time in minutes allowed for program, excluding cool-down.
Weight	1 (Lb)	350 (Lb)	155 lbs	Default (to user), typical weight in lb (UNITS=English), or kg
	1 (KG)	158 (KG)	70 (KG)	(UNITS=Metric).
Language	N/A	N/A	ENGL	Language is English (ENGL), Dutch (DUTC), French (FREN), German (GERM),
				Portuguese (PORT), Spanish (SPAN), Swedish (SWED), Italian (ITAL) or
				Katakana (KATA).

MAINTENANCE MODE

Your Service Representative may need to check accumulated data about the past usage of your STAR TRAC E-ST STEPPER, test its display controls, or investigate error messages. For these reasons, your Stepper is equipped with a Maintenance Mode. The Maintenance Mode includes all of the items available through Manager Mode, plus additional items for Service and Diagnostic use. To enter Maintenance Mode:

1.Press and hold the , and keys together.

2.A beep will sound and “MAINTENANCE MODE” will display momentarily in the Information Window.

3.Release all keys. “SERIAL NO #####” will display in the Information Window.

The following keys are available in MAINTENANCE MODE:

Upper and Lower Data Information Window SCROLL Keys: Display the next and previous parameters, respective- ly. Keys will repeat if held.

Increase and Decrease LEVEL Keys: Adjust the value of the displayed parameter up and down, respectively, in incre- ments of 1 unit. These keys do not save the new value - see OK Key below.

Numeric Keypad: Allows you to enter specific values for numeric parameters. These keys do not save the new value - see OK Key below.

OK Key: Updates (saves) the values of all parameters in non-volatile memory, and exits Maintenance Mode.

NOTE: To exit Maintenance Mode without saving any values or settings, press the QUICK START key.

The items that you may display and change with the previous keys are:

STAR TRAC E-ST STEPPER OWNER’S MANUAL 27