Spalding M88724C1 manual Shown Figure a

Page 15

	13.	Before starting rim assembly, tighten nut (26) until it is positioned 6-3/4” from the end of the rod (14) as
	13.	shown (Figure A).
		shown (Figure A).

Remove rim cover (16), attach rim assembly (3) to backboard (13) and reattach rim cover (16).

** For rim assembly, see instructions included with rim.

14

26

FIGURE

A.

5

6

6

13

IMPORTANT!

Carefully cut and peel protective film away from board prior to attaching rim.

Rim Assembly

3

15

15

7 7

16

Refer To Instructions

Included With Rim

Hardware For Rim

Assembly.

15

08/06

ID# M88724C1

Image 15

Contents High End Residential In-Ground Basketball System Safety Instructions Parts List Hardware Identifier Bolts & Screws Install nuts 25 onto the ground tube bolts as shown Build drainage hill Side ViewPlaying Surface Shown Insert bushings 19 into areasMounting plate 2 as shown Playing SurfaceCompleted Assembly Lower yokes 17 & 18 to pole as shown While still in forward position, attach both upperLower yoke Attach elevator adjustment 12 toAttach elevator adjustment 12 to pole bracket First attach board 13 to upper yoke Using TWO people to hold the boardAttach backboard 13 to upper and lower Yokes 18Shown Figure a Screws 29 into place with a Phillips head screwdriver Apply height indicator labels 32 & 31 to height indicatorsAttach height indicators Install net 4 to rim as shownNing Remove cotter pin 9, and pull out pin 8. This will allow After pole has been secured to anchor plate 2 loosen nutCheck system leveling. Pole Should be level in all directionsAfter system is leveled, completely tighten all nuts Limited Lifetime Warranty