REMOVE”.
4.Press SET.
5.Press ST/LAP/+ to select which device to delete.
6.Press SET to confirm selection.
CALIBRATING PAIRED DEVICE
The watch will not show “CAL DEVICE” if no device is paired.
You can calibrate by running, walking or inputting parameter. The parameter is the same value after you have successfully calibrated by running or walking.
If you want to calibrate the device immediately after pairing, go directly to step 4. Otherwise, start from the beginning.
CALIBRATE BY RUNNING OR WALKING
1.Press MODE repeatedly to select
.
2.Press SET.
3.Press ST/LAP/+ repeatedly to select “CAL DEVICE”.
4.Press SET.
5.Press ST/LAP/+ to select “CAL BY RUN” or “CAL BY WALK”.
6.Press SET to confirm selection.
7.The watch will conduct a device search first, as
indicated by flashing | and | . Wait until | stops |
flashing, then press SET to start calibration. |
| ||
8. Ensure to complete | walking or running the selected | ||
distance for calibration. | EN |
|
ØIf calibration is successful, the watch will display
or 
Run parameter Walk parameter
NOTE The Run parameter and Walk parameter is the value to enter when calibrating by inputting parameter.
ØIf calibration fails, the watch will display
NOTE The SZ909 chest belt should be calibrated both by running and walking.
SE833 EN 11.indd 11
11
6/1/09 10:07:22 AM