Oregon Scientific SE833 user manual Display, Starting Your Watch First Time, Setting UP Your Watch

DISPLAY

1
2	13
3	12
4
5	11
6

	7 8	9	10
1.	: Key to press indicator
2.	or : Indicates battery power is low or empty

3./ : 12 hour clock

4.: Press the key to exit

5.: Indicates up / down or upper / lower limit

6.: Indicates beep tone is off

7.: Indicates exercise timer is activated

8.: Indicates alarm is on

SE833 EN 11.indd 3

	EN
9.	: Indicates heart rate signal is received or heart rate
	chest belt is paired
10.	: Indicates speed and distance signal is received or
	foot pod is paired
11.	: Indicates bike and cadence signal is received or
	bike pod is paired

12. : Resolutions per minute (unit of cadence)

13.: Indicates keypad is locked

OPERATING MODES

STARTING YOUR WATCH (FIRST TIME)

After removing the watch from the package, activate it by pressing and holding MODE until the display is shown. The watch will prompt you to set your user profile.

SETTING UP YOUR WATCH

IMPORTANT

•To ensure accurate calculations with your exercise, you are strongly required to set the watch and user profiles before exercising.

•Remember to set the profiles after every battery replacement or reset.

NOTE When the watch is left idle for 30 seconds during set up, it will automatically exit.

3

6/1/09 10:06:52 AM