JVC CA-NXHD10R manual Introduction, Precautions

Page 6

Introduction

We would like to thank you for purchasing one of our JVC products. Before operating this unit, read this manual carefully and thoroughly to obtain the best possible performance from your unit, and retain this manual for future reference.

About This Manual

This manual is organized as follows:

This manual mainly explains playback and editing operations using the remote control, and the other operations such as recording operations using the buttons on the unit.

You can use the buttons both on the remote control and on the main unit for the same operations if they have the same or similar names (or marks), unless mentioned otherwise.

The following marks are used in this manual:

Gives you warnings and cautions to prevent from damage or risk of fire/electric shock. Furthermore, gives you information which is not good for obtaining the best possible performance from the unit.

Gives you information and hints you had better know.

Precautions

Installation

This unit has a built-in HDD, which is a device to read minute magnetic changes. The inside of the device is precision components, requiring you to notice the following when installing the unit:

Install the unit at a place where the following conditions are satisfied:

Level, dry and neither too hot nor too cold—between 5˚C and 35˚C.

At an altitude between –300 m below sea level and + 3048 m above sea level.

With adequate ventilation to prevent internal heat buildup in the unit.

Leave sufficient distance between the unit and the TV.

Keep the speakers away from the TV to avoid interference with TV.

• DO NOT install the unit in a location near heat sources, or in a place subject to direct

sunlight, excessive dust or vibration.

DO NOT place the unit with the side panels top and bottom.

About the built-in HDD

While the unit is turned on, the hard disk is constantly rotating at a high speed. This requires you to notice the following:

DO NOT impart vibration or shock.

DO NOT allow anything having strong magnetism or emitting strong electromagnetic waves (cellular phones, etc.) near the unit.

DO NOT disconnect the power plug from the wall outlet when the unit is turned on.

Failure in following the above cautions may damage the HDD (the stored data will be lost and be never restored).

Since the HDD has its lifetime, it is strongly recommended to make a copy of your important recordings, and keep it using other recording devices.

Power sources

When unplugging the unit from the wall outlet, always pull the plug, not the AC power cord.

DO NOT handle the AC power cord with wet hands.

Moisture condensation

Moisture may condense on the lens inside the unit in the following cases:

After starting heating in the room

In a damp room

If the unit is brought directly from a cold to a warm place Should this occur, the unit may malfunction. In this case, leave the unit turned on for a few hours until the moisture evaporates, unplug the AC power cord, then plug it in again.

Others

Should any metallic object or liquid fall into the unit, unplug the unit and consult your dealer before operating any further.

If you are not going to operate the unit for an extended period of time, unplug the AC power cord from the wall outlet.

DO NOT disassemble the unit since there are no user serviceable parts inside.

If anything goes wrong, unplug the AC power cord and consult your dealer.

– 1 –

Image 6
Contents CA-NXHD10R LVT0859-004AIf in Doubt Consult a Competent Electrician Class Laser Product Front view Side viewTo keep the continuity of the recorded sounds Precautions IntroductionContents Inside of Front Door Display Window Location of the ButtonsFront Panel Become familiar with the buttons on your unitDisplay Window How to open the front doorFront Panel To close the doorRemote Control When using the remote controlUnpacking Connecting AntennasGetting Started FM antennaAM MW/LW antenna Connecting SpeakersYou can connect the speakers using the speaker cords To connect an outdoor AM MW/LW antennaTo remove the speaker grille Connecting Other EquipmentEx. When connecting a cassette deck Speaker grilles are removable as shown belowPutting the Batteries into the Remote Control Connecting a keyboardBasic Settings Remote controlFront panel Turning On the Power Setting the ClockChanging the Display Contrast To adjust the clock againChanging the Display Brightness To turn on/off the clock indicationBasic and Common Operations Line Adjusting the VolumeSelecting the Sources and Starting Play To select the CD player as the source, press CD 3/8Source indication canceled Adjusting the Bass and Treble SoundsAHB 1 AHB AHB OFF canceled Reinforcing the Bass SoundWhat is AAC? Using the AAC SoundsAAC Sound OFF Mono Film canceled Hall MID Night Head PhonesListening to FM and AM MW/LW Broadcasts FM AM Line Tuning in to a StationTo change the FM reception mode To change the information shown in the main displayPresetting Stations Tuning in to a Preset StationTo record a broadcast program automatically Searching for Programs by PTY Codes PTY Search Receiving FM Stations with RDSChanging the RDS Information PTYSwitching to a Program Type of Your Choice Temporarily Alarm function Test functionMore about the Enhanced Other Networks function Description of the PTY codes Playing Back the External Component Adjusting the Input Level Selecting the External ComponentFM AM Press SET to finish changing the source name To cancel the setting, press CancelChanging the Source Name Selected source name appears in the main displayPlaying Back CDs CD/CD-R/CD-RW Pqrs TUV WxyzPrecautions on CD Playback Playing Back the Entire CD-Normal PlayPrograming the Playing Order of the Tracks -Program Play To go to another track directly using the number buttonsBasic CD Operations To stop playback for a momentTo check the program contents Playing at Random-Random PlayTo modify the program Repeat 1TRK Repeating Tracks or CD-Repeat PlayProhibiting Disc Ejection-Disc Lock Repeat OFFPlaying Back the HDD Hard Disk Drive MarkLibraries Playing Back the Entire HDD Continuous PlayHow tracks are recorded into the HDD Press HDD 3/8Basic HDD Operations To locate a particular point in a track during playTo select another library Playing Tracks in an Album-Album PlayTo select another album HDD Album HDD LibraryTo go to another album in the same library, press Library indicator lights up on the displayTo go to another track in the same album, press ¢ or Album or Album repeatedlyRepeating Tracks-Repeat Play Random and indicators light up on the displayYou cannot cancel Repeat play during Random play All tracks in the HDD are played repeatedly and endlesslyAlbum T.? Canceled Last 10? Track title?Searching for Albums and Tracks to Play- Search Modes Track T.?Canceled Last 10? Press Enter Available symbols are as followsRepeat steps 4 1 and4 2 to enter other characters For Album Title SearchTo search for one of the last 10 albums recently Played or recorded-LASTAlbum No.? Recording into the HDD How the HDD separates the recorded tracks? Before You Start RecordingAbout the digital formats used for recordings About the maximum recording length for one trackSmart COMP. CD Auto REC Using Automatic Recording FunctionsCanceled TU Auto REC Press Select ¢ or Select 4to select ON? Press SETCD Auto Recording will be automatically canceled if CD and Auto indicators light up on the displayCD and Auto indicators go off To automatically record CDs-CD Auto RecordingTU Auto REC CanceledSmart Comp CD Auto REC How Tuner Auto Recording actually works?AAC128kbps AAC 96kbps PCM x1 REC PCM x4 REC PCM x2 REC Press REC Mode on the unit to select the recording modeRecording CDs Prepare a CDEntry flashes in the main display for a while To record a single track during playbackPress SET to finish the recording To stop while recording, pressAAC128kbps AAC 96kbps When the broadcast program ends, press 7 to stop recordingRecording FM/AM MW/LW Broadcasts To assign track numbers manually while recordingWhen playback ends, press 7 to stop recording Recording the External ComponentStart playback on the external equipment To cancel analog recording, press REC Start again To record CD into the HDD using analog recording modeWhen no sound comes in for more than 30 seconds To assign track numbers manually while recordingMaking Your Own Titles Mark 2-ABC 3-DEF GHI 5-JKL 6-MNO Pqrs 8-TUV 9-WXYZTo assign a title to an album Canceled Track EDIT?Assigning Titles to Albums and Tracks TITLE? LIB. EDIT? Album EDIT?To assign titles to tracks Press TITLE/EDIT again to exit from the title entry modeOn the remote control only Press HDD 3/8 Assign the title by referring on Press EnterEditing the HDD Mark 2-ABC 3-DEF GHI 5-JKL 6-MNO Pqrs 8-TUV 9-WXYZAlbum Editing Introducing HDD Editing FunctionsLibrary Editing Track EditingUnit enters the library name entry mode Press SET Press SET againLibrary name entry screen appears in the main display Press Select ¢ or Select 4to select Restoring the Libraries-RESTORECopying an Album-COPY Album Press SET Press EnterConfirmation screen appears in the main display Moving an Album-LIB. ChangeMaking a New Album-MAKE Album Press Select ¢ or Select 4 to selectErasing an Album-ERASE To make your best album laterPress Select ¢ or Select 4to select ERASE?, then press SET Erasing All Albums-ALL Erase Copying a Track-COPY TrackPress Enter again Currently selected track starts playing Press SET when you find the start point POSI.A for CopyAlbum selection screen appears Playback continues11Press Enter Moving a Track-MOVEPlayback stops, and the library selection screen appears Press Select ¢ or Select 4to select MOVE?, then press SETDividing a Track-DIVIDE Press Select ¢ or Select 4to select DIVIDE?, then press SETIf Cannot Entry LIB. appears in the main display Playback stops Press SET when you find the dividing pointJoining Tracks-JOIN To join the divided tracks, see the Join function thatTo divide the joined tracks, see the Divide function on Erasing a Track-ERASE TRKPress Select ¢ or Select 4to select tracks If Cannot Join appears in the main displayUsing the Timers Off /TIMER SleepUsing Recording Timer How Recording Timer actually worksMinute digit starts flashing Recording source setting screen appearsFM? AM? LINE? For each recording mode, seeFM? AM? CD? Using Daily TimerHow Daily Timer actually works LINE?* HDD?To turn on the Daily Timer, repeat , and press SET in step Using Sleep TimerHow Sleep Timer actually works 120To sleep with Sleep Timer and wake up with Daily Timer Using Auto Power OffTimer Priority To deactivate Auto Power Off, press A.P.offUsing an Optional Keyboard Keys Used for Operating This UnitOperating Procedures Using the Keyboard To assign an album title-F1To assign a track title-F2 To search for an album by its number-F5 To change a library name-F3To search for an album by entering its title-F6 To search for a track by entering its title-F7General Notes MaintenanceCleaning the unit Handling CDsSignification Solution MessagesMessage How to rebuild the HDD CannotSignification Possible Cause TroubleshootingCD playback Symptom ActionSymptom Possible Cause Action HDD recording HDD editingIf Level OVER! appears in the main display Possible Cause Action GeneralSpecifications Above ALL SP-NXHD10 Connection Anschluss RemarqueAansluitingen NotaCollegamento Tilslutning

CA-NXHD10R specifications

The JVC CA-NXHD10R is a compact, versatile audio system designed to deliver high-quality sound in a sleek, modern package. This system stands out with its unique combination of features, tools, and technologies that cater to both casual listeners and audiophiles alike.

One of the main features of the CA-NXHD10R is its powerful 2-way speaker system, which produces rich and clear audio across a wide frequency range. This ensures that users can enjoy their favorite music genres, from classical to rock, with the fidelity they deserve. The system is complemented by an integrated amplifier that delivers a robust output, making it suitable for home use as well as small gatherings.

The CA-NXHD10R boasts a built-in CD player, allowing users to enjoy their CD collections without the need for additional equipment. Additionally, the system is equipped with a USB port, providing an easy way to connect USB devices and play music directly from flash drives. The inclusion of Bluetooth technology adds a contemporary touch, enabling wireless streaming from smartphones and tablets. This makes it incredibly convenient for users to access a vast library of music from popular streaming services.

For those who appreciate radio, the JVC CA-NXHD10R features an FM/AM tuner with preset station memory, allowing easy access to favorite radio channels. The system is designed with user-friendly controls, including a remote control for added convenience. The clear LCD display ensures visibility, even in low-light conditions.

In terms of design, the CA-NXHD10R is compact yet stylish, fitting seamlessly into various interior spaces. Its elegant finish and modern aesthetics make it an attractive addition to any room.

Sound customization is another highlight, with built-in equalizer settings that allow users to adjust audio to their liking. Whether it’s boosting bass or enhancing treble, this feature caters to individual preferences, ensuring a personalized listening experience.

The JVC CA-NXHD10R is designed with durability in mind, providing a reliable audio solution that withstands the test of time. Its combination of diverse input options, powerful sound delivery, and user-friendly features makes it a well-rounded choice for anyone looking to elevate their audio experience. Overall, the CA-NXHD10R is an excellent option for those seeking a high-performance, aesthetically pleasing sound system.