Star Trac UB Sport Upright Bike manual Install the Rear Foot

Page 12

2. Install the Rear Foot

Lift up the rear of the bike frame and place the rear foot assembly in position under the frame, aligning the holes in the foot with the holes in the frame.

Using four M10 X 30 button head screws, secure the rear foot assembly to the frame. Tighten all four screws securely.

Step 2

3. Install the Display Console

NOTE: It is necessary to have one person support and position the display console while a second person makes the cable connections.

Carefully pull the cable bundle out of the lower neck on the bike frame. Use a pair of wire cutters or other suitable tool to cut and remove the tie wrap from the cable bundle.

Step 3a

Hold the display console neck approximately one inch from the neck brackets of the bike frame. Plug the display console power, main I/O and Coax cable into their mating connectors in the display console neck.

Step 3b

NOTE: The power connector is a “loose” fit. A strip of electrical tape for securing the power connector is provided inside the lower neck on the bike frame.

While holding the power cable connectors together, make a small “bundle” of the cable, and wrap with electrical tape to prevent the connectors from separating.

Step 3c

12

STAR TRAC SPORT BIKES OWNERS MANUAL

Image 12
Contents N E R ’ S M a N U a L Table of Contents Star Trac Sport Bikes O WNER’ S M Anual Introduction About this ManualSafety Instructions PrecautionsDo Not Veiligheidsinstructies WaarschuwingConsignes DE Securite Mise EN GardeSicherheitsvorschriften WarnungInstruzioni DI Sicurezza AttenzioneInstruções DE Segurança AdvertênciaInstrucciones DE Seguridad AdvertenciaChinese Safety Instructions Here SikkerhedsinstruktionerRåd AdvarslerJapanese Safety Instructions Here Assembly and Setup Sport Upright Bike Assembly SetupAssembly UnpackingInstall the Rear Foot Install the Seat Post Sport Recumbent Bike Assembly and Setup Install the Rear Foot Install the Seat Frame Seat Adjustments Display Panel FeaturesOperating Instructions Pedal Strap OperationProfile Window Using the Personal FAN Hints and Tips for Getting StartedCooldown Cycle To operate the bike during CooldownHeart Rate Monitoring Lockout ID ProcessingContact Heart Rate Monitoring Chest Strap Heart Rate MonitoringPreset Programs Quick StartManual Program To operate the Quick Start programBurn Calories Program To operate the Burn Calories programIncrease Endurance Program To operate the Increase Endurance programAdvanced Workouts Programs Heart Rate Control ProgramsTo operate the Constant Heart Rate Control program Program Heart Rate Training Range Upper LevelHeart Rate Training Range Lower Level Burn FAT Program Fitness TestTo operate the Burn FAT Control program Goal Workouts To operate the Fitness Test programTo operate the Calorie Goal program Auto Pilot Program To operate the Distance Goal programTo operate the Auto Pilot program Preventative Maintenance Manager / Maintenance ModeMaintenance Mode UNE UNMUNE UNM TIM WGT Troubleshooting START-UP Service MessagesRegulatory Information Star Trac Sport Bikes O WNER’ S M Anual Page Star Trac