49.Remove the "TRIAD LEG SYSTEM" decal from the Decal Sheet (not shown). Apply the decal to the corner of the Leg Press Plate (70).
50.Remove the ten small decals numbered "10" through "100" from the Decal Sheet (not shown). Apply the decals to the ten Weights
(79)in the indicated locations. The decal
numbered "10" should be applied to the top Weight; the decal numbered "100" should be applied to the bottom Weight.
49
"TRIAD LEG SYSTEM"
50
51. Remove the "INDEPENDENT | ACTION | 51 |
|
|
shown). Apply the decal to the Rear Upright (74). The lower end of the decal should be aligned with the cylinder axles.
Remove the "HOT" decal from the Decal Sheet (not shown). Apply the decal to the Rear Upright (74) above the indicated 5/16" Nytock Nut (4).
Remove the two "SPEED LINK" decals from the Decal Sheet (not shown). Apply the decals to the Left and Right Pedals (63, 64). Make sure that both decals are turned so the words "FAST" are toward the Upright (74).
"INDEPENDENTACTION
STEPPER"
Cylinder Axles
"SPEED LINK" Note: The words "FAST" must be at this end.
64
17