Sears 831.15931 owner manual Assembly

ASSEMBLY

Assembly requires two people and will take about 4 hours. The following tools (not Included) are

required: two 8" adjustable wrenches, a rubber mallet, a phillips screwdriver and a standard

screwdriver. Grease and a small bowl of soapy water are also required. As you assemble the cross training system, read each step and examine each drawing carefully. Make sure that all parts

are oriented as shown In the drawings. Refer to the PART IDENTIFICATION (ID) CHART accompa- nying this owner's manual for help identifying the small parts used in assembly. Due to the size and weight of the cross training system, it should be assembled in the place where it will be used. Place all parts of the cross training system in a cleared area and remove the packing materials; do not dispose of the packing materials until the cross training system is completely assembled.

. Press a 2" x 2"	Outer	Cap (36) onto each end
of the Stabilizer	(73).	36

Insert two 5/16" x 2 3/4" Carriage Bolts (35) and a 5/16" x 2 1/2" Carriage Bolt (22) up through the Stabilizer (73).

Insert two 5/16" x 2 1/2" Carriage Bolts (22) up
through the Base (69). Slide the-end of the					35
Base	over	the two 5/16"	x 2 3/4"	Carriage		36
Bolts	(35)	in the Stabilizer (73).			i
					22
2. Slide the Rear Upright (74) over the two
5/16"	x 2 3/4" Carriage		Bolts (35)	in the
Stabilizer (73) and Base (69). Make sure that
the Rear Upright is turned so the pedal axles					//74
are on the indicated side. Attach the Rear
					.._	Pedal axles
Upright with two 5/16" Nylock Nuts (4). Do not
					"_	must be on
fully tighten the Nylock Nuts yet.
					_4	this side

3.Slide the end of the Brace (56) that has an oblong hole in it over the 5/16" x 2 1/2" Carriage Bolt (22) in the Stabilizer (73). Attach the Brace with a 5/16" Nylock Nut (4). Do not fully tighten the Nylock Nut yet.

Attach the other end of the Brace (56) tothe
Rear	Upright (74)	with	a 5/16" x 2	1/2 wBolt
(20),	5/16" Washer	(10)	and 5/16"	Nylock Nut	2;

(4). 73

Tighten all Nylock Nuts used In assembly steps 1-3.