Sears 831.15931 owner manual Table of Contents

Page 2

TABLE OF CONTENTS

IMPORTANT

SAFETY

PRECAUTIONS

 

2

BEFORE

YOU BEGIN

...............................................................

 

3

ASSEMBLY..

.....................................................................

 

4

USING

THE

LIFESTYLER

SYSTEM 40

. .......................

19

TROUBLE-SHOOTING

AND MAINTENANCE

 

21

PART LIST/EXPLODED

DRAWING

 

22

ORDERING

REPLACEMENT

PARTS

Back

Cover

WARRANTY

..............................................................

 

Back

Cover

-IMPORTANT SAFETY PRECAUTIONS

WARNING: To reduce the risk of serious Injury, read the following Important safety precautions before using the cross training system.

1.Read all Instructions In this owner's manual and in the accompanying literature before using the cross training system. Use the cross training system only as described.

2.Inspect and properly tighten all parts of the cross training system each time you exercise. Replace any worn parts Immediately.

3.Keep your hands away from moving parts other than the designated handles. Always wear athletic shoes for foot protection.

4.Keep small children away from the cross training system at all times.

5.Never release the arms, leg lever, leg press plate, lat bar or nylon strap while weights are raised. The weights will fall with great force.

6.Always lock the arms In the stationary position with the 4 1/2" "L" pins except when per- forming the butterfly or reverse butterfly exercise.

,7. The reslstanne cylinders become very hot during use. Allow the resistance cylinders to cool before touching them. Cover the floor beneath the stepper for protection. A small amount of oll leakage Is normal for hydraulic cylinders.

8.When using the stepper, keep your feet on the pedals at all times. If you lift your feet off the pedals, the pedals may separate from the resistance cylinders, resulting In Injury.

9.Make sure that the cables remain on the pulleys as you use the cross training system.

10.The leg press frame can strike the end of the seat frame with great force when In use. Keep all parts of your body away from the end of the seat frame or serious Injury will occur.

11.If you feel pain or dizziness at any t!me while exercising, stop Immediately and begin cool-

Ing down.

_'

WARNING: Before beglnnlng thls or any exerclse program, consult your physlclan. Thls Is especlally Important for persons over the age of 35 or persons wlth pre-exlsUng health prob-

lems. Read all InstrucUons before uslng thls product. SEARS assumes no responslblllty for per- sonal Injury or property damage sustalned by or through the use of thls product.

Image 2
Contents Model No Serial No Table of Contents Before YOU Begin Assembly Round Inner Cap 30 into each side of the Arm Support Nylock Nuts until completeing stepEn the Nylock Nuts until completeing step Press two 1 3/4 x 1 3/4 Inner Caps 28 into Thou It -- tl-JuWith a 3/8 x 2 3/4 Bolt 16 and 3/8 Nylock Nut Four holes Must be on t 291616 I/ll With two 1/4 x 2Screws 9 and 1/4 Washers Tighten all Nylock Nuts used in assembly Steps Long Cable Under Bracket 97 with a 3/8 x 1 3/4 Bolt 3/8 Nylock Nut 2169Insert Attach the Cable to the same Bolt that was used \\\/I Bench Press Triad LEG System Page Using the Lifestyler System Changing the Weight SEnINGUsingthearmsin THEBUTrERFLYMODE CiseTROUBLE-SHOOTING and Maintenance Adjusting the CablesPart LIST/EXPLODED DRAWING--Model No 4442 Ordering Replacement Parts Full 90 DAY Warranty