37.Slide the end of the Long Cable (93) onto the end of the 3/8" x 3 1/2" Bolt (5) in the Top
Brace (86). Slide a 3/8" Washer (8) onto the Bolt and tighten the 3/8" Jam Nut (7) onto the Bolt. Note'- The 3/8" x 3 1/2" Bolt (5) Is the
Bolt that was used In assembly step 24. The Bolt will already have one Nut thread- ed onto It. The step described above will attach the Long Cable to the remaining threads so there will be two Nuts on the
Bolt.
38.Slide the Leg Press Plate (70) onto the end of the Leg Press Frame (72). Insert the 7" "L"
Pin (40) through the Leg Press Plate and one of the four holes in the Leg Press Frame.
39.Find the lower ends of the two Weight Guides
(83)(there are holes near the upper ends of the Weight Guides). Slide a Weight Bumper
(50)onto the lower end of each Weight Guide. Insert the Weight Guides into the bracket on the Base (69).
Fit theWeight Guides (83) into the recesses in the sides of the Weight (79) on the Weight Selector (82).
37
7
86
Attach the Cable to the same Bolt that was used in
24
38
72
40
70
39
40. Insert a 5/16" | x 4 | 1/4" Bolt (41) | through | the | 4O | |
upper end of one | of the Weight | Guides | (83). | |||
41 | ||||||
Slide a 2 5/8" | Metal Spacer (42) onto the Bolt |
| ||||
and insert the Bolt into the Top Brace (86). Tighten a ,_/16" Nylock Nut (4) onto the Bolt.
Attach the other Weight Guide (83) to the Top
Brace (86) in the same manner.
42 86
41
14