14, Place a Foot Pad (62) on the end of the Right Pedal (64). Attach the Foot Pad with a 1/2" Pan Screw (45).
Attach the other Foot Pad (62) to the Left Pedal (63) in the same manner.
15.Apply grease to the cylinder axles on the Rear Upright (74).
Slide a Cylinder Spacer (48) and a Resistance Cylinder (60) onto each cylinder axle. Hold a 1• Retainer Ring (47) and 5/8" Plastic Cap
(46)against the end of the left cylinder axle, Make sure that the teeth on the Retainer Ring
bend outward, Tap the Retainer Ring and Plastic Cap onto the cylinder axle. Attach a 1" Retainer Ring (47) and 5/8" Plastic Cap (46) to the right cylinder axle in the same manner,
16. Raise the Right Pedal (64) and rest it on the
hr:_ek_t _t fh_ Inw_r _nd nf th_ rinhf
Resistance Cylinder (60). Make sure that the bracket is in one of the slots under the Pedal.
Rest the Left Pedal (63) on the bracket at the lower end of the left Resistance Cylinder (60). Make sure that the brackets are in the same slots under both Pedals.
17, Attach the two VKR Arms (57) to the Rear Upright (74) with two 5/16" x 2 3/4" Bolts (3) and 5/16" Nylock Nuts (4),
45
63
15_/Grea_e
16 I/ll | IlL |
| i |
60
64
63
17
95
Press a 1 1/2" x 1 1/2" Inner Cap (95) into each VKR Arm (57),
95
57
4
57