8. Press two 1 3/4" x 1 3/4" Inner Caps (28) into | 8 |
each of the Arms (51).
Apply grease to the axles On the Arm Support (85). Slide an Arm (51) onto the right axle.
Hold two 1 5/16" Retainer Rings (38) and a 1" Plastic Cap (37) against the lower end of the axle. Make sure that the teeth on the Retainer Rings bend downward. Tap the Re- tainer Rings and Plastic Cap onto the axle.
Attach the other Arm (51) in the same manner.
Wet the lower ends of the Arms (51) and the insides of the two 6 1/2" Foam Pads (84) with soapy water. Slide the Foam Pads onto the Arms until the Foam Pads are 3" from the lower ends.
g.Insert the end of a Handle (52) that has a
,_u_ th_ou | it |
| _). | _._ I I U t;;; | ||
| II tLU | II_IIL | t"_1 III | _=;.,_ |
| |
|
|
|
| |||
5/16" Washer | (10) and 5/16" x 3/8" Metal | |||||
Spacer (13) | onto a 5/16" | x 2 1/4" | Bolt (14). | |||
Insert the Bolt through the Arm and the | ||||||
Handle. | Slide another 5/16" | Washer | (10) onto |
the Bolt | and tighten a 5/16" | Nylock Nut (4) | |
onto the | Bolt. |
|
|
Press a | 1" Round Inner Cap | (11) into | the |
Handle
Assemble a Handle (52) to the left Arm (51) in the same manner.
Wet the Handles (52) with soapy water and
slide a Handle Grip (53) onto each Handle.
28
51
53
14